资源列表

« 1 2 ... .57 .58 .59 .60 .61 762.63 .64 .65 .66 .67 ... 4311 »

[VHDL编程qfq

说明:移位相加乘法器设计。附有工程实例及ppt说明。-Add multiplier design shift. Ppt with example and descr iption.
<fddib> 在 2025-02-02 上传 | 大小:1.65mb | 下载:0

[VHDL编程5Divide

说明:用Verilog HDL语言写的标准的5分频程序,可以立即使用-Verilog HDL language used to write the standard procedure of 5 min frequency, you can immediately use
<wangfanlion> 在 2025-02-02 上传 | 大小:168kb | 下载:0

[VHDL编程LCDDriver-ML505-EDK10-1

说明:Sourcecode on MicroBlade processor for LCD driver on ML505 Xilinx Board
<phonglt03> 在 2025-02-02 上传 | 大小:896kb | 下载:0

[VHDL编程FPGA_SDRAM_PCI

说明:一个基于FPGA的PCI数据采集程序,包括SDRAM控制,PCI9054时序控制,开发语言verilog,开发环境quartus-FPGA-based PCI data acquisition procedures, including SDRAM control, PCI9054 timing control, the development of language verilog, development environment q
<李国扬> 在 2025-02-02 上传 | 大小:2.67mb | 下载:0

[VHDL编程FPGA_PCI_DATA

说明:一个基于FPGA的PCI数据发送程序,实现从计算机通过PCI9054向FPGA发送数据功能。开发语言verilog,开发环境quartus-FPGA-based PCI data distribution process, from the computer through the PCI9054 functions to send data to the FPGA. The development of language verilo
<李国扬> 在 2025-02-02 上传 | 大小:231kb | 下载:0

[VHDL编程topmodule3_comments

说明:it is a 1/2 k=3 viterbi deocder code written in VHDL.
<Abhishek> 在 2025-02-02 上传 | 大小:4kb | 下载:0

[VHDL编程FPGA_SOPC

说明:fpga的基础实验,SOPC的入门实验初学者-fpga experimental basis, SOPC beginners entry experiment
<郑志远> 在 2025-02-02 上传 | 大小:1.94mb | 下载:0

[VHDL编程HDB3_coder

说明:实现了将64K低速NRZ码复接成2.048M高速HDB3码及其解复接过程,同时还用同步状态机剔除假同步和假失步的状态 -Achieved the 64K low-speed NRZ code 2.048M into high-speed multiplexing and demultiplexing HDB3 code then the process also removed using false synchronous state
<陈涛> 在 2025-02-02 上传 | 大小:3mb | 下载:0

[VHDL编程serial_detector

说明:分别用行为级和门级VHDL的编程方法实现序列检测功能,程序清晰简单,是初学者很好的材料-Were treated with behavioral and gate-level VHDL programming sequence detection methods, procedures clear and straightforward, is a good material for beginners
<陈涛> 在 2025-02-02 上传 | 大小:373kb | 下载:0

[VHDL编程CRC32_DATA16

说明:IEEE 802.b CRC32 VHDL
<balance yeh> 在 2025-02-02 上传 | 大小:1kb | 下载:0

[VHDL编程61549837an_jian_qu_dou_dong

说明:VHDL编写的按键去抖程序!我也忘记是从哪下的了!希望对大家有用!-VHDL prepared Buffeting button to process!
<yangcheng> 在 2025-02-02 上传 | 大小:165kb | 下载:0

[VHDL编程sanxiangxinhaoyuan

说明:基于vhdl的三相信号源,可任意置频率和相位,还有调频输出模式,可以输出调频波-Vhdl-based three-phase signal source can be arbitrary frequency and phase of home, as well as frequency modulation output mode, you can output FM wave
<rd> 在 2025-02-02 上传 | 大小:1.03mb | 下载:0
« 1 2 ... .57 .58 .59 .60 .61 762.63 .64 .65 .66 .67 ... 4311 »

源码中国 www.ymcn.org