资源列表

« 1 2 ... .93 .94 .95 .96 .97 2798.99 .00 .01 .02 .03 ... 4311 »

[VHDL编程NANDFLASH

说明:用VHDL开发的NANDFLASH的读写程序,给出 NANDFLASH的时序正确的读写-NANDFLASH developed using VHDL to read and write the procedures, timing NANDFLASH give the correct reading and writing
<mxc> 在 2025-02-24 上传 | 大小:31kb | 下载:0

[VHDL编程CIC_deci4

说明:cic抽取滤波器ip核,用于射频采样数字下变频模块的核心数字信号处理部分.此ip核已经过ise10.2验证-CIC decimation by 4 filter,used in Direct RF sampling of GPS signal. the core dsp block in a frondend design
<mimidabuda> 在 2025-02-24 上传 | 大小:31kb | 下载:0

[VHDL编程SDHAnalysis

说明:光纤通信中的SDH数据帧解析及提取的VHDL实现源代码,共包含帧同步、E1及F1码流提取、DCC1码流提取、帧头开销串行输出四个主要模块-SDH fiber-optic communication data fr a me analysis and retrieval implementation of VHDL source code, include the fr a me synchronization, E1 and F1 st
<张晓彬> 在 2025-02-24 上传 | 大小:31kb | 下载:0

[VHDL编程xilinxIDE

说明:xilinx fpga 下的IDE控制器原代码,贡献一起学习-xilinx fpga controller under the IDE source code and contribute to study together
<fangming> 在 2025-02-24 上传 | 大小:31kb | 下载:0

[VHDL编程FPGA-Design

说明:FPGA设计流程指南 介绍基本的设计方法-FPGA Design Process Manual
<horse> 在 2025-02-24 上传 | 大小:31kb | 下载:0

[VHDL编程hdl

说明:
<yexianchun> 在 2025-02-24 上传 | 大小:31kb | 下载:0

[VHDL编程1553_enc_dec

说明:1553B编解码程序 verilog 描述-1553B codec procedures described in verilog
<pan> 在 2025-02-24 上传 | 大小:31kb | 下载:0

[VHDL编程code

说明:代码文件夹: ARVI_FSM.v为顶层文件,用于模拟时用。 dataHex.dat 为模拟输入文件(只有10行,象征的意思。实际我们模拟时,dataHex.dat文件足有1个多GB) dataFormat.dat为输入文件对应的带格式的文件 使用modelsim模拟时,将dataHex.dat名字改为CPUContext.txt 结果: result.txt -Code folder: AR
<Bell> 在 2025-02-24 上传 | 大小:31kb | 下载:0

[VHDL编程practica8

说明:practice manual of vhdl
<paredes_47> 在 2025-02-24 上传 | 大小:31kb | 下载:0

[VHDL编程module

说明:基于VHDL语言,设计7段LED液晶显示屏,可以下载到相关的xilinx开发板上进行验证-Based on the VHDL language, design 7 LED LCD screen, can be downloaded to the relevant board to verify the development of xilinx
<李超> 在 2025-02-24 上传 | 大小:31kb | 下载:0

[VHDL编程example2

说明:moore状态机程序 一共有四个状况,空闲 idle 等待 ready 信号准备好后进入判决状态 decision 否则继续等待 ready信号;判决状态 decision 中将 oe、we 信号置低,同时根据read_write 判定下一个状态是读状态 read 还是写状态 write;如果 read_write 为‘1’读状态 read,否则写状态write;读状态将oe 置高,we 置低;写状态将 oe 置低,we 置高。-m
<panda> 在 2025-02-24 上传 | 大小:31kb | 下载:0

[VHDL编程2x4_decoder

说明:2*4 decoder program in verilog
<sandeep> 在 2025-02-24 上传 | 大小:31kb | 下载:0
« 1 2 ... .93 .94 .95 .96 .97 2798.99 .00 .01 .02 .03 ... 4311 »

源码中国 www.ymcn.org