资源列表

« 1 2 ... .10 .11 .12 .13 .14 2815.16 .17 .18 .19 .20 ... 4311 »

[VHDL编程SpW_codec_perfect

说明:SpaceWire 编解码器完整验证,vhdl源程序,-SpaceWire compile a complete verification of decoder, VHDL source code,
<艾米丽> 在 2025-02-24 上传 | 大小:553kb | 下载:0

[VHDL编程spacewire_latest.tar

说明:SpaceWire接口,vhdl源程序,完整验证-SpaceWire interface, VHDL source code, the complete validation
<艾米丽> 在 2025-02-24 上传 | 大小:1.08mb | 下载:0

[VHDL编程01-NEC_1997_B

说明:简易数字频率计(1997年B题),本例程的rst(复位)键位于拨码开关的第1位(最右边),高电平有效。-Simple digital frequency meter Problem B (1997), the routine rst (reset) button is located in one of the DIP switch (far right), high effective.
<艾米丽> 在 2025-02-24 上传 | 大小:471kb | 下载:0

[VHDL编程02-NEC_1999_B

说明:数字有效值电压表(1999年B题),本例程的rst(复位)键位于拨码开关的第1位(最右边),高电平有效。-Digital rms voltmeter Problem B (1999), the routine rst (reset) button is located in one of the DIP switch (far right), active high.
<艾米丽> 在 2025-02-24 上传 | 大小:1.4mb | 下载:0

[VHDL编程03-NEC_2003_C

说明:移相信号发生器(2003年C题),verilog源程序,-Phase shift generator Problem C (2003), Verilog source code,
<艾米丽> 在 2025-02-24 上传 | 大小:322kb | 下载:0

[VHDL编程04-NEC_2003_C

说明:数字相位测量仪(2003年C题),verilog源程序-digital phase meter Problem C (2003), Verilog source code
<艾米丽> 在 2025-02-24 上传 | 大小:1.96mb | 下载:0

[VHDL编程05-NEC_2003_D

说明:简易逻辑分析仪(2003年D题),verilog源程序-Simple logic analyzer (, 2003 D), Verilog source code
<艾米丽> 在 2025-02-24 上传 | 大小:408kb | 下载:0

[VHDL编程06-NEC_2005_A

说明:06-正弦信号发生器(2005年A题),verilog源程序-06- sinusoidal signal generator (2005 A question), Verilog source code
<艾米丽> 在 2025-02-24 上传 | 大小:707kb | 下载:0

[VHDL编程alarm

说明:The red arrow showed the output became 8 when the measured temperature changed to 11°C. As shown by black arrow, the maximum output was 28. The program was run according to the proposed method.
<jayjay> 在 2025-02-24 上传 | 大小:99kb | 下载:0

[VHDL编程comp

说明:The red arrow showed the output became 8 when the measured temperature changed to 11°C. As shown by black arrow, the maximum output was 28. The program was run according to the proposed method.
<jayjay> 在 2025-02-24 上传 | 大小:112kb | 下载:0

[VHDL编程8.3-LCD

说明:FPGA驱动LCD显示中文字符程序及状态机的使用-FPGA to drive the LCD display Chinese characters procedures and the use of the state machine
<林高办> 在 2025-02-24 上传 | 大小:5kb | 下载:0

[VHDL编程curtain

说明:The red arrow showed the output became 8 when the measured temperature changed to 11°C. As shown by black arrow, the maximum output was 28. The program was run according to the proposed method.
<jayjay> 在 2025-02-24 上传 | 大小:112kb | 下载:0
« 1 2 ... .10 .11 .12 .13 .14 2815.16 .17 .18 .19 .20 ... 4311 »

源码中国 www.ymcn.org