资源列表

« 1 2 ... .50 .51 .52 .53 .54 27555.56 .57 .58 .59 .60 ... 33935 »

[VHDL编程Multiplier_quartus-II8.0

说明:在quartus II8.0中实现乘法器,进过仿真验证过的,没有问题。-In quartus II8.0 realization in on time-multiplier, entered the simulation validated, no problem.
<maochiheng> 在 2025-03-10 上传 | 大小:1.47mb | 下载:0

[单片机(51,AVR,MSP430等)8668

说明:美容美发仪器的C语言源代码,单片机采用的是51系列单片机,数码管显示,6路PWM输出,PWM大小可以通过按键控制。-Beauty salons equipment in C-language source code, the microcontroller uses 51 computers, digital display, 6-channel PWM output, PWM size can be controlled by but
<熊文> 在 2025-03-10 上传 | 大小:4kb | 下载:0

[单片机(51,AVR,MSP430等)STC_test_program

说明:STC单片机测试程序,包含定时器,输入,输出,走马灯,初学者值得一看,高手就闪过吧-STC chip testing procedures, including timers, input, output, like a revolving door, beginner worth a look, flashed it on the master
<李明> 在 2025-03-10 上传 | 大小:25kb | 下载:0

[DSP编程Lab06-C_ASM_student

说明:给定一段C语言主程序,在相应的子程序中编写加减乘除法的子程序并用参数传递的方法传递给主程序-Given a C language main program, written in the corresponding subtraction multiplication and division subroutine in a subroutine and use the method parameters passed to the m
<张帆帆> 在 2025-03-10 上传 | 大小:152kb | 下载:0

[DSP编程Lab07-FFT_Student

说明:通过DSP实现快速傅里叶正反变换以及滤波器的设计-Positive and negative by the DSP to achieve fast Fourier transform and filter design
<张帆帆> 在 2025-03-10 上传 | 大小:56kb | 下载:0

[VHDL编程POC

说明:用VHDL语言设计一个并行输出控制器POC,作为系统总线个打印机的借口-The purpose of this project is to design and simulate a parallel output controller(poc) which acts an interface between system bus and printer. The Altera’s Maxplus II EDA tool is reco
<张帆帆> 在 2025-03-10 上传 | 大小:465kb | 下载:0

[VHDL编程Quartus-book

说明:很好的一份初学者参考教程,有利于初学者快速地掌握Quartus ii的操作方法。-A good reference for beginners tutorial will help beginners to quickly master the Quartus ii methods of operation
<biyuming> 在 2025-03-10 上传 | 大小:12.29mb | 下载:0

[其他嵌入式/单片机内容DSP_Builder-jiaocheng

说明:一份有关Altera公司的DSP Builder的使用教程,有利于广大初学者参考.-A report on Altera' s DSP Builder to use tutorial will help the majority of beginners reference.
<biyuming> 在 2025-03-10 上传 | 大小:26.5mb | 下载:0

[单片机(51,AVR,MSP430等)lights

说明:P1口作为输出口,接8只发光二极管,编写程序,使发光二管循环点亮。相临灯切换的时间为0.1秒。-P1 port as output port, then eight light-emitting diode, programming, so that light emitting two cycles. Adjacent light switch time of 0.1 seconds.
<张帆帆> 在 2025-03-10 上传 | 大小:7kb | 下载:0

[单片机(51,AVR,MSP430等)wugongbuchang-

说明:这个一个关于基于单片机的无功控制器的原理图,是我帮客户开发的,可是使用。-The one on microcontroller-based reactive controller schematic diagram, is to help clients develop, but the use.
<wangzhongzhou> 在 2025-03-10 上传 | 大小:50kb | 下载:0

[嵌入式Linuxclass

说明:这个是对linux设备驱动中class类的操作,对大家有很好的学习帮助作用-This is a Linux device driver in the class operating, we have very good learning help
<丁泽荣> 在 2025-03-10 上传 | 大小:557kb | 下载:0

[嵌入式/单片机编程jiaotongdeng

说明:交通灯汇编语言版,使用于51单片机,原理正确,可放心下载!-Assembly language version of the traffic lights, used in 51 single-chip, the principle is correct, can be assured to download!
<陈泽帆> 在 2025-03-10 上传 | 大小:1kb | 下载:0
« 1 2 ... .50 .51 .52 .53 .54 27555.56 .57 .58 .59 .60 ... 33935 »

源码中国 www.ymcn.org