文件名称:1
介绍说明--下载内容均来自于网络,请自行研究使用
设计一个用于篮球比赛的定时器。要求:
(1)定时时间为24秒,按递减方式计时,每隔1秒,定时器减1;
(2)定时器的时间用两位数码管显示;
(3)设置两个外部控制开关,开关K1控制定时器的直接复位/启动计时,开关K2控制定时器的暂停/连续计时;当定时器递减计时到零(即定时时间到)时,定时器保持零不变,同时发出报警信号,报警信号用一个发光二极管指示。
(4)输入时钟脉冲的频率为50MHz.(Design a timer for a basketball match. Requirements:
(1) the timer time is 24 seconds and the timer is reduced by 1 second every second.
(2) the timer time is displayed with two digital tubes;
(3) set two external control switches, switch K1 control the direct reset/start time of the timer, switch K2 control timer pause/continuous time; When the timer decreases to zero (i.e., timing time), the timer stays zero and sends an alarm signal, indicating the alarm signal with a light-emitting diode.
(4) the frequency of input clock pulse is 50MHz.)
(1)定时时间为24秒,按递减方式计时,每隔1秒,定时器减1;
(2)定时器的时间用两位数码管显示;
(3)设置两个外部控制开关,开关K1控制定时器的直接复位/启动计时,开关K2控制定时器的暂停/连续计时;当定时器递减计时到零(即定时时间到)时,定时器保持零不变,同时发出报警信号,报警信号用一个发光二极管指示。
(4)输入时钟脉冲的频率为50MHz.(Design a timer for a basketball match. Requirements:
(1) the timer time is 24 seconds and the timer is reduced by 1 second every second.
(2) the timer time is displayed with two digital tubes;
(3) set two external control switches, switch K1 control the direct reset/start time of the timer, switch K2 control timer pause/continuous time; When the timer decreases to zero (i.e., timing time), the timer stays zero and sends an alarm signal, indicating the alarm signal with a light-emitting diode.
(4) the frequency of input clock pulse is 50MHz.)
(系统自动生成,下载前可以参看下载内容)
下载文件列表
文件名 | 大小 | 更新时间 |
---|---|---|
1.docx | 27681 | 2017-12-18 |