This example program shows how to configure and use the

A/D Converter of the following microcontrollers:



* Philips LPC 2114/2119/2124/2129/2131/2132/2138/2194



After configuring the A/D Converter, the program reads

A/D channel 0 and outputs the converted value using the serial

port.





To run this program...



1. Select the Device (Project - Options for Target - Device)

2. Build the project (Project - Build Target)

3. Start the uVision Debugger

4. Open the Serial Window (View - Serial Window 1)

5. Click Run (F5)

6. Click on the Toolbox buttons to change input voltages





A debug scr ipt (debug.ini) creates buttons that set different

analog values in A/D channels. As the program runs, you

will see the A/D input and output change.



Other buttons create signals that generate sine wave

or sawtooth patterns as analog inputs. µ Vision3 users may

enable the built-in Logic Analyzer to view, measure and compare

these input signals graphically.-This example program shows how to configure and use the

A/D Converter of the following microcontrollers:



* Philips LPC 2114/2119/2124/2129/2131/2132/2138/2194



After configuring the A/D Converter, the program reads

A/D channel 0 and outputs the converted value using the serial

port.





To run this program...



1. Select the Device (Project- Options for Target- Device)

2. Build the project (Project- Build Target)

3. Start the uVision Debugger

4. Open the Serial Window (View- Serial Window 1)

5. Click Run (F5)

6. Click on the Toolbox buttons to change input voltages





A debug scr ipt (debug.ini) creates buttons that set different

analog values in A/D channels.　As the program runs, you

will see the A/D input and output change.



Other buttons create signals that generate sine wave

or sawtooth patterns as analog inputs.　µ Vision3 users may

enable the built-in Logic Analyzer to view, measure and compare

these input signals graphically.