文件名称:UART
介绍说明--下载内容均来自于网络,请自行研究使用
CAN is a multi-master broadcast serial bus standard for connecting electronic control units (ECUs).
Each node is able to send and receive messages, but not simultaneously: a message (consisting primarily of an ID — usually chosen to identify the message-type/sender — and up to eight message bytes) is transmitted serially onto the bus, one bit after another — this signal pattern codes the message (in NRZ) and is sensed by all nodes.
Each node is able to send and receive messages, but not simultaneously: a message (consisting primarily of an ID — usually chosen to identify the message-type/sender — and up to eight message bytes) is transmitted serially onto the bus, one bit after another — this signal pattern codes the message (in NRZ) and is sensed by all nodes.
(系统自动生成,下载前可以参看下载内容)
下载文件列表
UART0\main_serial.c
.....\main_serial.crf
.....\main_serial.d
.....\main_serial.o
.....\SERIAL.axf
.....\SERIAL.hex
.....\SERIAL.htm
.....\SERIAL.lnp
.....\SERIAL.map
.....\SERIAL.Opt
.....\SERIAL.plg
.....\SERIAL.tra
.....\SERIAL.Uv2
.....\serial_driver.h
.....\SERIAL_Opt.Bak
.....\SERIAL_Target 1.dep
.....\SERIAL_Uv2.Bak
.....\Startup.lst
.....\Startup.o
.....\Startup.s
UART0
.....\main_serial.crf
.....\main_serial.d
.....\main_serial.o
.....\SERIAL.axf
.....\SERIAL.hex
.....\SERIAL.htm
.....\SERIAL.lnp
.....\SERIAL.map
.....\SERIAL.Opt
.....\SERIAL.plg
.....\SERIAL.tra
.....\SERIAL.Uv2
.....\serial_driver.h
.....\SERIAL_Opt.Bak
.....\SERIAL_Target 1.dep
.....\SERIAL_Uv2.Bak
.....\Startup.lst
.....\Startup.o
.....\Startup.s
UART0