文件名称:Interrupte
- 所属分类：
- 其他嵌入式/单片机内容
- 资源属性：
- [ASM] [源码]
- 上传时间：
- 2012-11-26
- 文件大小：
- 1kb
- 下载次数：
- 0次
- 提 供 者：
- 沈**
- 相关连接：
- 无
- 下载说明：
- 别用迅雷下载，失败请重下，重下不扣分！
介绍说明－－下载内容均来自于网络，请自行研究使用
由8031内部定时器1，按方式1工作，即作为16位定时器使用
每0.05秒钟T1溢出中断一次。P1口的P1.0-P1.7分别接八个发
光二极管。要求编写程序模拟一时序控制装置。开机后第一
秒钟L1，L3亮，第二秒钟L2，L4亮，第三秒钟L5，L7亮，第四
秒钟L6，L8亮，第五秒L1，L3，L5，L7亮，第六秒钟L2，L4，
L6，L8亮，第七秒钟八个二极管全亮，第八秒钟全灭，以后又
从头开始，L1，L3亮，然后L2，L4亮......一直循环下去。-Internal timer 1 by 8031, a work by the way, that is, to use as a 16-bit timer overflow every 0.05 seconds, T1 interrupt time. P1 port P1.0-P1.7, respectively, then the eight light-emitting diodes. Procedures require the preparation of a timing control device simulation. The first seconds after boot L1, L3-liang, the second a matter of seconds L2, L4-liang, the third seconds, L5, L7-liang, the fourth seconds, L6, L8-liang, the fifth sec L1, L3, L5, L7-liang, Sixth seconds L2, L4, L6, L8-liang, the seventh of eight seconds, the entire light diode, the eighth body seconds later to start from scratch again, L1, L3-liang, and then L2, L4 light ..... . has been the cycle continues.
每0.05秒钟T1溢出中断一次。P1口的P1.0-P1.7分别接八个发
光二极管。要求编写程序模拟一时序控制装置。开机后第一
秒钟L1，L3亮，第二秒钟L2，L4亮，第三秒钟L5，L7亮，第四
秒钟L6，L8亮，第五秒L1，L3，L5，L7亮，第六秒钟L2，L4，
L6，L8亮，第七秒钟八个二极管全亮，第八秒钟全灭，以后又
从头开始，L1，L3亮，然后L2，L4亮......一直循环下去。-Internal timer 1 by 8031, a work by the way, that is, to use as a 16-bit timer overflow every 0.05 seconds, T1 interrupt time. P1 port P1.0-P1.7, respectively, then the eight light-emitting diodes. Procedures require the preparation of a timing control device simulation. The first seconds after boot L1, L3-liang, the second a matter of seconds L2, L4-liang, the third seconds, L5, L7-liang, the fourth seconds, L6, L8-liang, the fifth sec L1, L3, L5, L7-liang, Sixth seconds L2, L4, L6, L8-liang, the seventh of eight seconds, the entire light diode, the eighth body seconds later to start from scratch again, L1, L3-liang, and then L2, L4 light ..... . has been the cycle continues.
相关搜索： interrupte
(系统自动生成,下载前可以参看下载内容)
下载文件列表
Interrupted from time to time the application.asm