资源列表

« 1 2 ... .55 .56 .57 .58 .59 1660.61 .62 .63 .64 .65 ... 16930 »

[编程文档usb_msc_cbi_1.1

说明:USB海量存储规范CBI,CBI传输协议则用Control/Bulk/Interrupt三种类型的端点进行数据/命令/状态的传送-USB Mass Storage standard CBI. CBI transmission protocol used Control/Bulk/Interrupt three types of endpoint for data/order/delivery status
<林德> 在 2025-02-04 上传 | 大小:138kb | 下载:0

[编程文档Embedded-Programming-Guide

说明:USB OTG控制芯片ISP1362的编程向导,英文的,不过很容易看明白-USB OTG Controller ISP1362 programming guides, in English, but very easy to understand this
<林德> 在 2025-02-04 上传 | 大小:1.4mb | 下载:0

[技术管理MyBigIntdata

说明:有关长整形数据的相关问题, 我的一些理解-the long plastic data related issues, my understanding
<李锐> 在 2025-02-04 上传 | 大小:8kb | 下载:0

[文档资料3rdlayerswitchersoftware

说明:这是关于以太网的一本硕士学位论文, 是关于三层交换机的软件设计与实现的-on Ethernet is a master of the paper is on the three-tier exchange software design and implementation of
<lixiuru> 在 2025-02-04 上传 | 大小:3.05mb | 下载:0

[文档资料ethernetxieyiandinterface

说明:这是一本关于以太网的协议和接口技术研究的硕士学位论文-This is an agreement on the Ethernet interface technology and a master's degree thesis research
<lixiuru> 在 2025-02-04 上传 | 大小:979kb | 下载:0

[文档资料IEEE8021xbasedethernetMAC

说明:这是一本硕士学位论文,名字是基于IEEE8021的以太网接入控制芯片的设计-This is a master's degree thesis, whose name is based on the IEEE8021 Ethernet Access Control Chip Design
<lixiuru> 在 2025-02-04 上传 | 大小:6.15mb | 下载:0

[文档资料signalintegrityoffastethernet

说明:这是一本硕士学位论文,是关于快速以太网信号完整性的-This is a master's degree thesis on the Fast Ethernet Signal Integrity
<lixiuru> 在 2025-02-04 上传 | 大小:3.68mb | 下载:0

[软件工程IntroToCortex-M3

说明:An Introduction to the ARM Cortex-M3 Processor! General Informations about the CM3.
<alexm_92> 在 2025-02-04 上传 | 大小:319kb | 下载:0

[软件工程chess_improve

说明:棋类博弈算法的改进:瞿锡泉,白振兴,包建平.基于博弈树的构建,对传统的博弈算法进行了分析研究,指出了其存在的不足。提出改进传统算法的三种可行技术,并通过实例进行了验证。 -chess game algorithm improvements : Jixi spring, and white revitalization, including the Jianping. Based on Game Tree Construction,
<覃丽萍> 在 2025-02-04 上传 | 大小:40kb | 下载:0

[软件工程ly56446

说明:基本模型机的设计与实现主要内容: 设计一个较为完整的计算机、并编写一些简单的指令 基本要求: 设计器材: Dais-CMH+/CMH 计算器组成原理教学实验系统一台,实验用扁平线、导线若干。 设计目的: ⒈ 在掌握部件单元电路实验的基础上,进一步将其组成系统地构造一台基本模型计算机。 ⒉ 为其定义5条机器指令,并编写相应的微程序,上机调试掌握整机概念。 实现较为完整的计算机、并编写一些简单的指令。 设计目标
<刘洋> 在 2025-02-04 上传 | 大小:37kb | 下载:0

[技术管理OpenAL

说明:openal三维声音开发包的权威程序员手册-openal 3D sound development kits authority programmers manual
<lhg> 在 2025-02-04 上传 | 大小:5kb | 下载:0

[软件工程MATLAB5.X

说明:matlab的学习书籍,供工程技术人员以及大学教师和学生使用的一本好书。-Matlab learning books for engineering and technical personnel as well as university teachers and students use of a good book.
<于志强> 在 2025-02-04 上传 | 大小:4.76mb | 下载:0
« 1 2 ... .55 .56 .57 .58 .59 1660.61 .62 .63 .64 .65 ... 16930 »

源码中国 www.ymcn.org