[数学计算/工程计算] Efficient-processing-of-multiple-contacts-in-MPP-

说明：Complex models often contain more than just a few contact interfaces. The decomposition of such a model can result in an uneven distribution of these contacts among the available processors. Some contacts may lie who
<Tianma> 在 2025-02-19 上传 | 大小：492kb | 下载：0

[数学计算/工程计算] Failure-modeling-of-a-self-piercing-riveted-joint

说明：Besides the basic product requirements, the aspect of energy efficiency is in the center of automobile engineering. A mixture of different light weight materials like aluminium and higher strength steels
<Tianma> 在 2025-02-19 上传 | 大小：1.76mb | 下载：0

[数学计算/工程计算] FEM-study-of-metal-rolling-in-grooved-rolls

说明：LS-DYNA was used to model the rolling process in grooved rolls. One-pass and two-pass (with rotation of the metal sheet at 90° a fter first pass) rolling in grooved rolls, as well as four-pass rolling in plain roll
<Tianma> 在 2025-02-19 上传 | 大小：300kb | 下载：0

[数学计算/工程计算] Finite-element-analysis-of-localised-impact-loadi

说明：This paper investigates low velocity impact involving a glass fibre-reinforced polyamide engine oil pan as part of a complete new development of thermoplastic components. The assessment of the impact resistance has drive
<Tianma> 在 2025-02-19 上传 | 大小：385kb | 下载：0

[数学计算/工程计算] Finite-element-dynamic-simulation

说明：Side impact accidents against a tree or pole remainthe most dangerous accident scenarios in rally cars. Statistical data shows that 52 of the fatalities between 2004 and 2009 concern crashes against a rigid pole by
<Tianma> 在 2025-02-19 上传 | 大小：783kb | 下载：0

[数学计算/工程计算] Hail-impact-simulation-on-CFC-covers-of-a-transpo

说明：Due to increasing weight saving requirements in new aircraft, structures traditionally built from aluminium alloys are increasingly replaced by carbon bre reinforced Composites (CFC).
<Tianma> 在 2025-02-19 上传 | 大小：1.53mb | 下载：0

[数学计算/工程计算] How-to-use-LS-OPT-for-parameter-estimation

说明：The “direct” heat transfer problem is one inwhich material properties and boundary conditions are specified, and LS-DYNA [1] is used to calculate the temperature response of the nodes in the mesh.
<Tianma> 在 2025-02-19 上传 | 大小：276kb | 下载：0

[数学计算/工程计算] Hypervelocity-impact-of-aluminium-sphere

说明：High velocity impact of 3 mm diameter aluminium sphere against thin aluminium target plate has been performed at impact velocity of about 4000 m/s withthe two stage light gas gun HERMES at Thiot Ingenierie laborato
<Tianma> 在 2025-02-19 上传 | 大小：991kb | 下载：0

[数学计算/工程计算] Impact-simulations-on-concrete-slabs-LS-OPT-fitti

说明：This paper is based on a work realized for an international OECD benchmark initiated by IRSN and CNSC. The main goal of IRIS_2010 Benchmarkwas to uate the ability of simulation to reproduce experimental tests of im
<Tianma> 在 2025-02-19 上传 | 大小：231kb | 下载：0

[数学计算/工程计算] Implementation-of-a-strain-rate-dependent-human-b

说明：Strain rate dependency of mechanical properties of cortical bone has been well demonstrated in literature studies. Nevertheless, the majority of these studies have been done on nonhuman bone and at lower magnitudes of
<Tianma> 在 2025-02-19 上传 | 大小：154kb | 下载：0

[数学计算/工程计算] Incompressible-CFD-results-using-LS-DYNA-for-high

说明：This report will provide some insight on the new incompressible CFD solver that will be available in version 980 of LS-DYNA.
<Tianma> 在 2025-02-19 上传 | 大小：511kb | 下载：0

[数学计算/工程计算] Influence-of-HE-shape-on-blast-profile

说明：This paper is concerned by the effect of HE geometry on the shape of the blast wave. The aim of this work is to increase the knowledge on pressure profile generated by blast wave so as to optimize the design of explos
<Tianma> 在 2025-02-19 上传 | 大小：500kb | 下载：0