资源列表

« 1 2 ... .00 .01 .02 .03 .04 2105.06 .07 .08 .09 .10 ... 4311 »

[VHDL编程nexy3

说明:fpga板 deligent 公司的 nexys3 开发板的原理图,给大家看下吧,很有用-fpga board deligent' s nexys3 development board schematics for everyone to look it, very useful
<刘飞> 在 2025-04-24 上传 | 大小:1.69mb | 下载:0

[VHDL编程DVRcn

说明:这是我亲自完成的dvr一体机之后所写的CCTV_10.2寸完整的规格书,已经开始大量了。-This is my personal one machine after the completion of the dvr written CCTV_10.2 inch complete specification, has started a lot of.
<柳莺> 在 2025-04-24 上传 | 大小:639kb | 下载:0

[VHDL编程INTERC51CPLD

说明:51CPU与LATTICE的cpld的接口程序 -INTERFACE of 51cpu and CPLD
<yangyiping> 在 2025-04-24 上传 | 大小:1kb | 下载:0

[VHDL编程WaterLight

说明:基于FPGA的入门程序:流水灯源代码Verilog语言编写-Based on FPGA introduction program: water light source code Verilog language
<hu wen> 在 2025-04-24 上传 | 大小:304kb | 下载:0

[VHDL编程std_1076

说明:VHDL标准介绍,热衷于语法及标准写法的定义,微电子具有很高的参考价值-VHDL standard introduction, keen on grammar and writing standards for the definition of micro-electronics with high reference value
<李仕意> 在 2025-04-24 上传 | 大小:10.56mb | 下载:0

[VHDL编程matrixKeyboard_seg7

说明:基于Verilog实现的矩阵键盘扫描和数码管动态显示-Verilog-based implementation of matrix keyboard scanning and LED dynamic display
<许地> 在 2025-04-24 上传 | 大小:98kb | 下载:0

[VHDL编程uart_tx_test

说明:基于verilog的串口uart发送端实现-Verilog-based serial transmitter to achieve
<许地> 在 2025-04-24 上传 | 大小:242kb | 下载:0

[VHDL编程uart_rx_test

说明:基于verilog的串口uart发送端实现-Verilog-based serial uart transmitter to achieve
<许地> 在 2025-04-24 上传 | 大小:333kb | 下载:0

[VHDL编程lcd12864_test

说明:基于quartus nios的LCD显示-The LCD display on quartus nios
<许地> 在 2025-04-24 上传 | 大小:1.07mb | 下载:0

[VHDL编程SRAM

说明:实现3,8译码器的源码,编译过,很好用,-Achieve 3,8 decoder source code, compiled, very good, Oh
<成语> 在 2025-04-24 上传 | 大小:2.92mb | 下载:0

[VHDL编程S8_test

说明:本程序用来测试开发板上所有的设备。 1、VGA输出8位色彩的条纹; 2、PS/2键盘输入字符可以传输到LCD和串口调试终端上; 4、拨码与按键开关与4位LED相连-The procedure used to test all the equipment development board. 1, VGA output 8-bit color stripes 2, PS/2 keyboard input characters
<成语> 在 2025-04-24 上传 | 大小:1.62mb | 下载:0

[VHDL编程S7_PS2_RS232

说明:本实验实现PS/2接口与RS-232接口的数据传输, PS/2键盘上按下按键,可以通过RS-232自动传送到主机的串口调试终端上(sscom32.exe); 并在数据接收区显示接收到的字符。 串口调试终端的设置:波特率115200,一个停止位,无校验位。 -The experimental realization of PS/2 interface and RS-232 interface, data transmiss
<成语> 在 2025-04-24 上传 | 大小:1.78mb | 下载:0
« 1 2 ... .00 .01 .02 .03 .04 2105.06 .07 .08 .09 .10 ... 4311 »

源码中国 www.ymcn.org