资源列表

« 1 2 ... .63 .64 .65 .66 .67 31568.69 .70 .71 .72 .73 ... 33935 »

[单片机(51,AVR,MSP430等)LCD1602

说明:LCD液晶驱动程序,基于单片机AT89C52-LCD liquid crystal driver, based on single-chip microcomputer AT89C52
<凌思佳> 在 2025-03-12 上传 | 大小:1kb | 下载:0

[单片机(51,AVR,MSP430等)LED_DISPLAY

说明:LED DISPLAY SCAN PROGRAM
<SHJDW> 在 2025-03-12 上传 | 大小:1kb | 下载:0

[嵌入式Linuxdrawicon

说明:用minigui编写的系统界面加载图标与去掉图标的程序-Prepared by the system interface minigui icon and remove the icon to load the program
<emma> 在 2025-03-12 上传 | 大小:1kb | 下载:0

[单片机(51,AVR,MSP430等)led

说明:一个可以对寄存器直接赋值的示例程序,不需要复杂的地址映射。-A direct assignment of the sample register procedures, no complicated address mapping.
<zhang> 在 2025-03-12 上传 | 大小:1kb | 下载:0

[嵌入式Linuxled_driver

说明:数字显示驱动程序,应用于嵌入式linux s3c2410-Figures show that the driver used the embedded linux s3c2410
<zhang> 在 2025-03-12 上传 | 大小:1kb | 下载:0

[VHDL编程VHDL

说明:用VHDL写的代码,实现任意整数分频,自己只要修改分频参数即可。希望对大家有用-Written in VHDL code used to achieve arbitrary integer frequency, their frequency as long as the modified parameter. We hope to be useful
<tianson> 在 2025-03-12 上传 | 大小:1kb | 下载:0

[VHDL编程tt

说明:判断电机转向,并实现分轴比输出脉冲数的VHDL代码。-Determine the motor shift, and the axial ratio at the output pulses of the VHDL code.
<tianson> 在 2025-03-12 上传 | 大小:1kb | 下载:0

[VHDL编程t1

说明:实现电机M/T法测速的VHDL代码,只要修改cnt值大小即可修改M/T法切换的频率,当小于cnt时为T法,大于时为M法。-Motor M/T method velocimetry of the VHDL code, as long as the modified value of cnt to modify the size of M/T method of frequency switching, when cnt is less t
<tianson> 在 2025-03-12 上传 | 大小:1kb | 下载:1

[VHDL编程clock

说明:FPGA实现电子时钟,可以设置为12小时制和24小时制!-FPGA electronic clock can be set to 12-hour system and 24-hour system!
<tianson> 在 2025-03-12 上传 | 大小:1kb | 下载:0

[单片机(51,AVR,MSP430等)I2C_c51_all

说明:I2C串行总线标准驱动程序,c51,软件模拟i2c时序-i2c standard driver
<sangreal> 在 2025-03-12 上传 | 大小:1kb | 下载:0

[单片机(51,AVR,MSP430等)pules

说明:51脉冲信号发生器,实现脉冲信号输出!简单但好用!-51-pulse signal generator, to achieve pulse signal output! Simple but good!
<李明> 在 2025-03-12 上传 | 大小:1kb | 下载:0

[单片机(51,AVR,MSP430等)i2c-hard

说明:用c语言实现24LC256读写(非软件模拟方式)-硬件i2c应用-24LC256 using c language reading and writing (non-simulation software)- Application of hardware i2c
<sangreal> 在 2025-03-12 上传 | 大小:1kb | 下载:0
« 1 2 ... .63 .64 .65 .66 .67 31568.69 .70 .71 .72 .73 ... 33935 »

源码中国 www.ymcn.org