资源列表

« 1 2 ... .59 .60 .61 .62 .63 26364.65 .66 .67 .68 .69 ... 33935 »

[嵌入式/单片机编程i2c_eeprom

说明:EEPROM编程,可以实现各种方式的EEPROM编程-EEPROM programming can be achieved in various ways EEPROM programming
<gedpe> 在 2024-10-20 上传 | 大小:6144 | 下载:0

[嵌入式/单片机编程i2c_module

说明:PIC16F877 based communication module which performs serial (UART) to i2c translation in mixed bus environment. Module was originally used to add multiple i2c communication modules to ARM based CPU which had only UART com
<库文件名> 在 2024-10-20 上传 | 大小:6144 | 下载:0

[嵌入式/单片机编程iic_mdd

说明:这个是wince6.0 S3C6410平台下 IIC驱动的源码分析,写的很好很标准,有很强的通用性。-This is wince6.0 S3C6410 platform source code under the IIC-driven analysis, written in a very good standard, has a strong general.
<sistheg> 在 2024-10-20 上传 | 大小:6144 | 下载:0

[微处理器(ARM/PowerPC等)graph

说明:随机生成有向无环图,统计节点的入度和出度并转换成十字链表-There are no plans to randomly generate statistics ring node degree and out-degree and converted Crusaders
<魏凯嘉> 在 2024-10-20 上传 | 大小:6144 | 下载:0

[嵌入式/单片机编程install

说明:the ndis driver ,you must install the inf file-the ndis driver, you must install the inf file
<Thiis> 在 2024-10-20 上传 | 大小:6144 | 下载:0

[嵌入式/单片机编程intrrupt

说明:一个外部中断的列子,描述了利用单片机指令,进行多IO口操作的中断处理。-An external interrupt Liezi, describes the use of microcomputer instruction, multi-IO port interrupt handling operations.
<pperc> 在 2024-10-20 上传 | 大小:6144 | 下载:0

[嵌入式/单片机编程IOsimulateUART

说明:IO 口模拟232通讯程序使用两种方式的C程序-IO mouth simulation 232 communications programs use two methods of C Program
<Onamo> 在 2024-10-20 上传 | 大小:6144 | 下载:0

[嵌入式/单片机编程irdamsp430

说明:Example for realization of IrDA for MSP430 microcontrollers
<rterwill> 在 2024-10-20 上传 | 大小:6144 | 下载:0

[嵌入式/单片机编程kalman

说明:kalman滤波 加 小波阀门滤波法该文为陀螺仪滤波程序-kalman filter
<环境光> 在 2024-10-20 上传 | 大小:6144 | 下载:1

[VHDL编程VGA

说明:VGA屏幕显示,verilog语言,分模块文件rtl_test_vga_grid,vga_grid,vga_signal,vga_sync,希望对您有用。-VGA,verilog language,module are rtl_test_vga_grid,vga_grid,vga_signal,vga_sync,i help it s useful to you .
<shanshan> 在 2024-10-20 上传 | 大小:6144 | 下载:0

[单片机(51,AVR,MSP430等)11

说明:利用定时/计数器T0从P1.0输出周期为1s的方波,让发光二极管以1HZ闪烁,设晶振频率为12MHz-The use of timer/counter T0 from P1.0 output cycle square wave 1s, so that the light-emitting diodes 1HZ blinking, set the crystal frequency is 12MHz
<曾华> 在 2024-10-20 上传 | 大小:6144 | 下载:0

[单片机(51,AVR,MSP430等)22

说明:利用定时/计数器T1产生定时时钟,由P1口控制8个发光二极管,使8个指示灯依次一个一个闪动,闪动频率为10次/秒(8个灯依次亮一遍为一个周期),循环-The use of timer/counter T1 timing clock generated by the P1 port to control 8 LEDs, making eight lights were flashing one by one, the flashing f
<曾华> 在 2024-10-20 上传 | 大小:6144 | 下载:0
« 1 2 ... .59 .60 .61 .62 .63 26364.65 .66 .67 .68 .69 ... 33935 »

源码中国 www.ymcn.org