资源列表

« 1 2 ... .32 .33 .34 .35 .36 25437.38 .39 .40 .41 .42 ... 33935 »

[其他嵌入式/单片机内容Boot-from-the-start(mega64)

说明:工作芯片为mega64,GPIOD(6)上接一个继电器,程序上电后将PORTD(6)置1,延时1.5S后关闭继电器。将继电器接到主机的启动引脚上,即可实现开机自启动。PS,适合那些老主板,没有开机自启功能的主板。-Work chip mega64, then a relay GPIOD (6) on the program after power PORTD (6) is set to 1, after a delay 1.5S clo
<杨杰> 在 2025-02-05 上传 | 大小:9kb | 下载:0

[单片机(51,AVR,MSP430等)PIC16F97PeV1527

说明:PIC16F97+eV1527解码源程序-PIC16F97+eV1527 code
<蔡生> 在 2025-02-05 上传 | 大小:9kb | 下载:0

[嵌入式LinuxA8-i2c

说明:在cortex-A8上实现裸机的I2C通信-Achieve bare metal in the cortex-A8 I2C communication
<marco11> 在 2025-02-05 上传 | 大小:9kb | 下载:0

[单片机(51,AVR,MSP430等)ledyidongshan

说明:单片机开发环境 led等闪烁 移动闪烁-Microcontroller development environment movement led flashes and other flashes
<> 在 2025-02-05 上传 | 大小:9kb | 下载:0

[单片机(51,AVR,MSP430等)music

说明:单片机小实验,红外遥控器控制蜂鸣器的音乐转换,信息在LCd显示屏上显示-SCM small experiment, infrared remote control buzzer Music Converter, information is displayed on the display LCd
<倪力烽> 在 2025-02-05 上传 | 大小:9kb | 下载:0

[单片机(51,AVR,MSP430等)RFID

说明:arduino平台RC522,RFID库及例程-arduino platform RC522, RFID libraries and routines
<bo> 在 2025-02-05 上传 | 大小:9kb | 下载:0

[嵌入式LinuxMux-0710

说明:多路复用协议gms0710源码,C语言实现-the code of gsm0710 protocol
<赵力力> 在 2025-02-05 上传 | 大小:9kb | 下载:0

[单片机(51,AVR,MSP430等)13072912543632

说明:单片机与蓝牙模块的串口通信程序,程序语言说明-Serial communication program between single chip computer and Bluetooth module
<李文> 在 2025-02-05 上传 | 大小:9kb | 下载:0

[其他嵌入式/单片机内容DynamicLED_Key

说明:DynamicLED_Key的程序,可以使用按键实现在屏幕上显示相应的数字。-DynamicLED_Key program, you can use the buttons for the display the corresponding number on the screen.
<樊梦雅> 在 2025-02-05 上传 | 大小:9kb | 下载:0

[单片机(51,AVR,MSP430等)51-USART--tiaoshi

说明:51单片机 开发板 串口调试 能实现板上的功能- USART 51 51 MCU development board serial debugging function enables board
<金坛树 > 在 2025-02-05 上传 | 大小:9kb | 下载:0

[微处理器(ARM/PowerPC等)51-microcontroller-interrupt-system

说明:51单片机中断系统的解释 (中断、定时器)-The interpretation of the 51 SCM interrupt system (interrupt, timer)
<duanyang> 在 2025-02-05 上传 | 大小:9kb | 下载:0

[uCOS开发ili9341_driver_for_ucgui

说明:大多数的ili9341的驱动代码仅仅可以让TFT正常显示,但是读点函数却是不对的,本驱动为正确的代码-Most ili9341 driver code can only make TFT display properly, read some function but it is not right, this drive is the correct code
<张彦兮> 在 2025-02-05 上传 | 大小:9kb | 下载:0
« 1 2 ... .32 .33 .34 .35 .36 25437.38 .39 .40 .41 .42 ... 33935 »

源码中国 www.ymcn.org