资源列表
[单片机(51,AVR,MSP430等)] dianjikozhi
说明:这是我做的最复杂的C51对电机的和数码管等的控制,内部的脚口设置挺复杂的,得仔细研究。-This is what I do the most complex C51 and digital control of motors and other control port to set foot inside the quite complex, and too carefully.<lh> 在 2025-02-08 上传 | 大小:1kb | 下载:0
[单片机(51,AVR,MSP430等)] adc350
说明:C8051F350 24或16位 ADC 可编程转换速率,可达1 ksps-C8051F350 24 or 16-bit ADC programmable conversion rate, up to 1 ksps<sundeyuan> 在 2025-02-08 上传 | 大小:1kb | 下载:0
[微处理器(ARM/PowerPC等)] UART
说明:单片机串口通信,收发数据缓冲区示例,在中断中不处理接收的数据,只是按循环队的方式将数据存起来,标示Buf中有多少个数据,在主程序中去查询.-Microcontroller serial communication, send and receive data buffer example, in the interrupt does not handle the data received, but on a revolving tea<zhang> 在 2025-02-08 上传 | 大小:1kb | 下载:0
[VHDL编程] StepperMotorports
说明:基于FPGA环境下步进电机控制模块程序实现-FPGA-based stepper motor control module Environment Program Realization<zheshu> 在 2025-02-08 上传 | 大小:1kb | 下载:0
[单片机(51,AVR,MSP430等)] 51MCUSJA1000
说明:基于51系列单片机的can总线驱动器 sja1000的驱动程序 本程序基于c8051f系列同样有用-Based on 51 Series MCU can bus drivers drive sja1000 This procedure would also be useful based on the c8051f Series<晨曦> 在 2025-02-08 上传 | 大小:1kb | 下载:0
[VHDL编程] BasedonFPGASteppingMotorController
说明:这是我收集的基于FPGA的步进马达控制器,仅供初学者参考。-Based on FPGA Stepping Motor Controller<刘先生> 在 2025-02-08 上传 | 大小:1kb | 下载:0