资源列表
[单片机(51,AVR,MSP430等)] KEYPWM
说明:stm32f103rct6的按键控制输出脉冲的占空比(The stm32f103rct6 button controls the duty cycle of the output pulse)<青涩 > 在 2025-02-06 上传 | 大小:2.5mb | 下载:0
[单片机(51,AVR,MSP430等)] 计数器外部测速
说明:PA0口输入捕获可以测量低频信号 3000hz(PA0 port input acquisition can measure low frequency signals)<青涩 > 在 2025-02-06 上传 | 大小:5.2mb | 下载:0
[单片机(51,AVR,MSP430等)] 程序
说明:这是一个做串口测试的程序,下来直接用,用串口小助手发送小写返回大写。(This is a serial test procedures, down directly, with a small serial assistant to send lowercase to return capital.)<淇淇 > 在 2025-02-06 上传 | 大小:25kb | 下载:0
[嵌入式/单片机编程] 串行A/D、D/A转换器与89C51单片机的接口设计
说明:串行A/D、D/A转换器与89C51单片机的接口设计(nterface design of serial A / D, D / A converter and 89C51 MCU)<she > 在 2025-02-06 上传 | 大小:116kb | 下载:0
[单片机(51,AVR,MSP430等)] 电子钟
说明:电子时钟,使用51单片机可以实现记时,定时的目的(The use of 51 single-chip electronic clock, can achieve timing, timing purpose)<请问让他 > 在 2025-02-06 上传 | 大小:31kb | 下载:0
[单片机(51,AVR,MSP430等)] PADS9.5实战攻略与高速PCB设计
说明:详细介绍了利用PADS 9.5 实现原理图与PCB设计的方法和技巧。配合大量示意图,介绍了印制电路板设计流程和常用电路模块的PCB处理方法(The method and technique of using PADS 9.5 to realize schematic diagram and PCB design are introduced in detail. With a large number of schematic diag<Grace_jq > 在 2025-02-06 上传 | 大小:42.4mb | 下载:0
[VHDL编程] Design-VGA-Verilog
说明:FPGA VGA例程驱动程式,用Verilog语言来编写的。(FPGA VGA routines driver, written in Verilog language.)<神通广大 > 在 2025-02-06 上传 | 大小:7.64mb | 下载:0
[单片机(51,AVR,MSP430等)] 多合一code
说明:采用51单片机作为主控制器,通讯方式为485总线,通讯协议为Modbus,波特率为9600,8位数据,1个停止位,无校验位; 本程序作为从机部分编写的;(Using 51 single-chip microcomputer as the main controller, communication mode is 485 bus, communication protocol is Modbus, baud rate is 9600,<wzc1992 > 在 2025-02-06 上传 | 大小:94kb | 下载:0
[嵌入式/单片机编程] 1602上进行PS2的解码
说明:LCD的显示类型为1602,在1602上显示C51单片机对PS2键盘接口的解码实时显示(The display type of LCD is 1602, and the decoding of PS2 keyboard interface is displayed on C51 at 1602)<神通广大 > 在 2025-02-06 上传 | 大小:34kb | 下载:0