资源列表

« 1 2 ... .19 .20 .21 .22 .23 1024.25 .26 .27 .28 .29 ... 33935 »

[其他嵌入式/单片机内容modbusRtu

说明:little modbus RTU stack with crc calculation for microcontrollers
<Vasia> 在 2025-02-12 上传 | 大小:4kb | 下载:0

[VHDL编程verilogiic1121

说明:一个基于verilog的iic协议的控制器,用状态机结构编写,可以将数据写入eeprom中,再读出来。-A protocol based on verilog for iic controller state machine structure with writing, data can be written to the eeprom, reading them out.
<陈栋磊> 在 2025-02-12 上传 | 大小:130kb | 下载:0

[VHDL编程uartfifo

说明:一个基于verilog的fifo的例子,由数据产生模块产生数据传到fifo中,然后同过发送模块将数据发到上位机上。-One based on the fifo verilog example, by the data generation module generates data to the fifo, and then sent over the same module sends data to the host compute
<陈栋磊> 在 2025-02-12 上传 | 大小:646kb | 下载:0

[VHDL编程EX7

说明:一个基于verilog的串口接收发送模块,可与上位机通信。-One based on the serial receiver sends verilog module can communicate with the host computer.
<陈栋磊> 在 2025-02-12 上传 | 大小:319kb | 下载:0

[VHDL编程logic_analysis

说明:一个基于verilog的逻辑分析仪,可以通过pc机的显示器将开发板的数据显示在显示频上。-Verilog based logic analyzer, you can monitor the development pc machine data plate on the display frequency.
<陈栋磊> 在 2025-02-12 上传 | 大小:2.93mb | 下载:0

[VHDL编程verilogsram

说明:一个基于verilog的sdram读写控制器,可以将数据写入sdram并读回。-One based on the sdram verilog write controller, data can be written to and read back sdram.
<陈栋磊> 在 2025-02-12 上传 | 大小:94kb | 下载:0

[其他嵌入式/单片机内容LEDliushuideng

说明:利用ADC的第14通道对开发板上单圈电位器的电压值作AD转换,采用连续转换模式,转换结果通过DMA通 道1读取。ADC转换的结果,每间隔1秒钟向串口发送一次。-The ADC' s first 14-channel single-turn potentiometer on the development board, the voltage value for the AD converter, using the conti
<guohuiyuan> 在 2025-02-12 上传 | 大小:1.98mb | 下载:0

[嵌入式Linuxfont_wenquanyi

说明:Qt中用于嵌入式的文泉驿字体,,12号的到16号的字体,qpf格式-In Qt for Embedded WenQuanYi fonts
<jack> 在 2025-02-12 上传 | 大小:2.52mb | 下载:0

[DSP编程serial-bootloader-SPI-mode

说明:红尘编写的串行FLASH烧写详细讲解,里面详细介绍了关于DSP5509的自举及串行FLASH烧定步骤。-Red serial FLASH programmer to write detailed explanations, which elaborated on the DSP5509 bootstrap and serial FLASH burning fixed steps.
<谢佛昌> 在 2025-02-12 上传 | 大小:393kb | 下载:0

[DSP编程exam_SDreadwrite

说明:使用SD卡功能对SD卡进行读写,注意SD卡必须是标准SD卡-Using an SD card function on the SD card reader, pay attention to the SD card must be a standard SD card
<谢佛昌> 在 2025-02-12 上传 | 大小:816kb | 下载:0

[DSP编程TMS320VC5509A_program

说明:TMS320VC5509A开发板全套开发例程,共有24个!并附有说明文档。-TMS320VC5509A development board complete development of routines, a total of 24! Together with documentation.
<谢佛昌> 在 2025-02-12 上传 | 大小:7.59mb | 下载:0

[其他嵌入式/单片机内容指纹采集及显示

说明:本代码详细介绍了触摸屏触摸响应及LCD显示和指纹模块的指纹采集,指纹显示等功能
<879975932@qq.com> 在 2013-09-26 上传 | 大小:649.35kb | 下载:0
« 1 2 ... .19 .20 .21 .22 .23 1024.25 .26 .27 .28 .29 ... 33935 »

源码中国 www.ymcn.org