资源列表

« 1 2 ... .43 .44 .45 .46 .47 28448.49 .50 .51 .52 .53 ... 33935 »

[微处理器(ARM/PowerPC等)TWO-MOTOR-MPU6050

说明:应用于两轴飞行器的测试,能测试多轴或者两轴飞行器DIY的两轴平衡控制,空间姿态解算-Used in aircraft testing two axes, to test the multi-axis or two-axis aircraft DIY balance control two axes, spatial attitude solution
<石磊> 在 2025-03-16 上传 | 大小:1.43mb | 下载:0

[微处理器(ARM/PowerPC等)stm32-fatfsPsd

说明:stm32 SPI接口 fatfs下sd卡读写-stm32 SPI fatfs sd card
<唐寅> 在 2025-03-16 上传 | 大小:3.78mb | 下载:0

[嵌入式Linuxuboot-analysis-report-20120310

说明:介绍uboot的目录结构和启动流程,以及uboot的命令执行过程,uboot如何向内核传递参数-Uboot procedure describes the directory structure and start the process, as well as uboot command execution, uboot how to pass parameters to the kernel
<王长清> 在 2025-03-16 上传 | 大小:309kb | 下载:0

[嵌入式LinuxStart-on-embedded-Linux-systems

说明:嵌入式Linux启动分为两个部分,系统引导与Linux启动。系统引导将完成Linux装入内存前,初始化CPU和相关IO设备,并将Linux调入内存的工作。系统引导主要由BootLoader实现。在BootLoader将Linux内核调入内存之后,将权力交给LinuxKernel,进入Linux的启动部分。本文详细分析启动的过程与使用。-Embedded Linux boot is divided into two parts, the
<王长清> 在 2025-03-16 上传 | 大小:23kb | 下载:0

[其他嵌入式/单片机内容AT24C02

说明:STC89C52单片机控制AT24C02,AT24C02是存储芯片,能够进行掉电存储-STC89C52 SCM AT24C02, AT24C02 is a memory chip that can be powered down storage
<wangsong> 在 2025-03-16 上传 | 大小:5.99mb | 下载:0

[单片机(51,AVR,MSP430等)GPS-program-12864-display-

说明:GPS测试程序,在12864显示器上并行显示相应地理数据-GPS test program,the result can be displayed by 12864 screen.
<456> 在 2025-03-16 上传 | 大小:56kb | 下载:0

[单片机(51,AVR,MSP430等)qiyaATmega328

说明:基于ATMEGA328的气压传感器的应用-Based on the application of pressure sensors ATMEGA328
<yrz> 在 2025-03-16 上传 | 大小:24kb | 下载:0

[单片机(51,AVR,MSP430等)C

说明:51单片机,实现在3.2寸LED屏显示图片的C程序-51 single, implemented in 3.2-inch LED screen display pictures of C program
<Jack wu> 在 2025-03-16 上传 | 大小:176kb | 下载:0

[单片机(51,AVR,MSP430等)sxd-sch

说明:dsp28335和w5300的开发板原理图,sxd开发板,淘宝上很畅销的。-develop board of dsp28335 and w5300
<guyh> 在 2025-03-16 上传 | 大小:243kb | 下载:0

[VHDL编程adc0809

说明:1、用状态机设计A/D转换器ADC0809的采样控制电路,并在数码管上显示转换结果; 2、设置有复位和启动/保持开关,要求 ⑴ 复位开关用来使A/D转换器复位,并做好A/D转换准备; ⑵ 启动/保持开关用来控制A/D转换器开始连续转换或停止转换保持结果,即按一下启动/保持开关,启动A/D转换器开始转换,再按一下启/停开关,停止转换并保持结果。 3、采用Verilog HDL语言设计符合上述功能要求的控制电路。-1, wi
<YINJIE> 在 2025-03-16 上传 | 大小:106kb | 下载:0

[VHDL编程decoder

说明:学习使用结构描述方法(层次设计),设计4位二进制计数器7段数码显示译码器;学习和掌握模块例化语句应用。-Learn to use the structure described methods (hierarchical design), design 4 binary counter 7-segment display decoder learn and master module instantiation statement a
<YINJIE> 在 2025-03-16 上传 | 大小:99kb | 下载:0

[VHDL编程jc1101

说明:用状态机实现序列检测器的设计,了解有限状态机的设计与应用。-With a state machine sequence detector design, understand the design and application of finite state machines.
<YINJIE> 在 2025-03-16 上传 | 大小:195kb | 下载:0
« 1 2 ... .43 .44 .45 .46 .47 28448.49 .50 .51 .52 .53 ... 33935 »

源码中国 www.ymcn.org