文件名称:802.11a
介绍说明－－下载内容均来自于网络，请自行研究使用
802.11协议簇是国际电工电子工程学会（IEEE）为无线局域网络制定的标准。虽然WI-FI使用了802.11的媒体访问控制层（MAC）和物理层（PHY），但是两者并不完全一致。在以下标准中，使用最多的应该是802.11n标准，工作在2.4GHz频段，可达600Mbps（理论值）。-802.11 protocol stack is a standard international Institute of Electrical and Electronic Engineering (IEEE) wireless local area network developed. Although the use of WI-FI 802.11 MAC layer (MAC) and physical layer (PHY), but the two are not exactly the same. In the following standards, use the most should be the 802.11n standard, work in the 2.4GHz band, up to 600Mbps (theoretical value).
(系统自动生成,下载前可以参看下载内容)
下载文件列表
802.11a
.......\00815305.pdf
.......\00887490.pdf
.......\802.11a中文.pdf
.......\channel.m
.......\create_freq_offset.m
.......\get_bits_per_symbol.m
.......\get_channel_ir.m
.......\get_n_antennas.m
.......\get_punc_params.m
.......\hs_err_pid3712.log
.......\phase_noise_model.m
.......\readme.txt
.......\receiver.m
.......\runsim.m
.......\rx_bpsk_demod.m
.......\rx_deinterleave.m
.......\rx_demodulate.m
.......\rx_depuncture.m
.......\rx_diversity_proc.m
.......\rx_estimate_channel.m
.......\rx_find_packet_edge.m
.......\rx_fine_time_sync.m
.......\rx_frequency_sync.m
.......\rx_gen_chan_amps.m
.......\rx_gen_deintlvr_patt.m
.......\rx_init_viterbi.m
.......\rx_mr_combiner.m
.......\rx_phase_tracker.m
.......\rx_pilot_phase_est.m
.......\rx_qam16_demod.m
.......\rx_qam64_demod.m
.......\rx_qpsk_demod.m
.......\rx_radon_hurwitz.m
.......\rx_timed_to_freqd.m
.......\rx_viterbi_decode.m
.......\set_sim_consts.m
.......\single_packet.m
.......\transmitter.m
.......\tx_add_cyclic_prefix.m
.......\tx_add_pilot_syms.m
.......\tx_conv_encoder.m
.......\tx_diversity.m
.......\tx_freqd_to_timed.m
.......\tx_gen_intlvr_patt.m
.......\tx_gen_preamble.m
.......\tx_interleaver.asv
.......\tx_interleaver.m
.......\tx_make_int_num_ofdm_syms.m
.......\tx_modulate.m
.......\tx_power_amplifier.m
.......\tx_puncture.m
.......\tx_radon_hurwitz.m
.......\ui_check_params.m
.......\ui_read_options.m
.......\ui_start.m
.......\ui_start.mat
.......\ui_start_sim.m