文件名称:UIP-UDP-mega64-enc28J60
介绍说明－－下载内容均来自于网络，请自行研究使用
UIP协议在AVR单片机+ENC28J60上的移植实现,熔丝位设置：低位[CE],高位[99],扩展位[FF]
接线说明：SPI的三根线直接连接，CS片选接到mega64单片机的PB0 SS即可。-In AVR to achieve+ENC28J60 microcontroller on the transplantation of UIP protocol, fuse bit settings: low [CE], high [99], extended [FF]
Wiring instructions: three lines of SPI directly connected, CS chip selection to mega64 microcontroller PB0 SS.
接线说明：SPI的三根线直接连接，CS片选接到mega64单片机的PB0 SS即可。-In AVR to achieve+ENC28J60 microcontroller on the transplantation of UIP protocol, fuse bit settings: low [CE], high [99], extended [FF]
Wiring instructions: three lines of SPI directly connected, CS chip selection to mega64 microcontroller PB0 SS.
(系统自动生成,下载前可以参看下载内容)
下载文件列表
AVR
...\Mega64
...\......\mega64-enc28J60
...\......\...............\net
...\......\...............\...\avr_compat.h
...\......\...............\...\default
...\......\...............\...\.......\dep
...\......\...............\...\.......\...\enc28j60.o.d
...\......\...............\...\.......\...\ip_arp_udp_tcp.o.d
...\......\...............\...\.......\...\main.o.d
...\......\...............\...\.......\...\timeout.o.d
...\......\...............\...\.......\enc28j60.o
...\......\...............\...\.......\ip_arp_udp_tcp.o
...\......\...............\...\.......\main.o
...\......\...............\...\.......\Makefile
...\......\...............\...\.......\net.eep
...\......\...............\...\.......\net.elf
...\......\...............\...\.......\net.hex
...\......\...............\...\.......\timeout.o
...\......\...............\...\enc28j60.c
...\......\...............\...\enc28j60.h
...\......\...............\...\ip_arp_udp_tcp.c
...\......\...............\...\ip_arp_udp_tcp.h
...\......\...............\...\main.c
...\......\...............\...\net.aps
...\......\...............\...\net.aws
...\......\...............\...\net.h
...\......\...............\...\timeout.c
...\......\...............\...\timeout.h
...\......\...............\ReadMe.txt
ENC28J60.BOM
ENC28J60.pdf