看门狗程序



安装说明



安装



1.把两个文件(wego.ini、wego.exe)拷贝到要安装的目录

2.正确配置好wego.ini文件

意义为：

[Ports_Information]

下面是硬件狗的串口号,一定不要配置错误(如果错了，我不负责)

CommPort=1



[Para_Information]

下面是喂狗周期，单位为秒

TokenInternal=10



3.在“COMMAND”(即DOS命令提示符)模式下进入刚才的安装目录,执行 wego -install (不带任何参数，您将得到帮助)

4.进入系统的“控制面板”，打开“服务”项界面,找到“ WeGoManage” 按“开始”

按钮启动此服务，然后按“启动”按钮将其设置为“自动”启动类型。

5.如果启动出动错，请检查安装目录/LOG下当日的LOG文件内容，找出相应的解决办法



注意：为确保正确，建议第一次启动后检查一次log文件，经核对是否出错。

如果你配置的串口在后来的工作中出现错误，程序会间断发出提示蜂鸣音,这时你可检查LOG文件。





反安装

1.在“COMMAND”模式下进入安装目录,执行 wego -remove-Watchdog program



Installation Instructions



Installation



Copy the two files (wego.ini, wego.exe) to the directory you want to install

Properly configured wego.ini file

　　Significance:

　 [Ports_Information]

　　 Here is the serial number of the hardware dog must not configuration errors (if wrong, I am not responsible)

　　　CommPort = 1

　

　 [Para_Information]

　　 Below to feed the dogs cycle seconds

　　　TokenInternal = 10



"COMMAND" (ie, the DOS command prompt) mode to enter just the installation directory, execute wego-install (without any parameters, you will get help)

Into the system "control panel" to open the "Services" entry interface, find "WeGoManage" Press Start "

　 Button to start the service, and then press the "start" button is set to "Automatic" startup type.

5 If you start mobilized wrong, please check the date under the installation directory/LOG LOG file contents, find the appropriate solution



　Note: To ensure correct, it is reco