彩条信号发生器使用说明使用模块有：VGA接口、脉冲沿模块、时钟源模块。 使用步骤：1.打开电源+5V2.信号连接，按下表将1K30信号与实际模块连接好。3.1K30板板连接好并口线，并将程序源码加载。4.将将彩色显示出来器的线与VGA接口连接好。5.彩条信号就能在显示出来器中产生，通过脉冲沿模块按键MS1能改变产生彩条的 可直接使用。

-The color bar signal generator using the module: VGA interface, the pulse along the module, the clock source module. Use these steps: 1. Turn on the power+5V2. Signal connected to the table below will the 1K30 signal with the actual module connected. 3.1K30 plate board to connect the parallel cable and program source code to load. The color display out of line with the VGA interface of the device is connected. The color bar signal can be displayed, the device in the color bar can be used directly by MS1 change the pulse along the module button.