文件名称:msp430x41x
介绍说明--下载内容均来自于网络,请自行研究使用
低电源电压范围为1.8 V至3.6 V
超低功耗:
- 主动模式:280μA,在1 MHz,2.2伏
- 待机模式:1.1μA
- 关闭模式(RAM保持):0.1μA
五省电模式
欠待机模式唤醒
超过6微秒
16位RISC架构,
125 ns指令周期时间
12位A/ D转换器具有内部
参考,采样和保持,并
AutoScan功能
16位Timer_B随着三† 或七‡
捕捉/比较随着阴影寄存器
具有三个16位定时器A
捕捉/比较寄存器
片上比较器
串行通信接口(USART),
选择异步UART或
同步SPI软件:
- 两个USART(USART0 USART1)的†
- 一个USART(USART0)‡
掉电检测
电源电压监控器/监视器
可编程电平检测
串行板载编程,
无需外部编程电压
安全可编程代码保护
融合-Low Supply-Voltage Range, 1.8 V to 3.6 V
Ultralow-Power Consumption:
− Active Mode: 280 µ A at 1 MHz, 2.2 V
− Standby Mode: 1.1 µ A
− Off Mode (RAM Retention): 0.1 µ A
Five Power Saving Modes
Wake-Up From Standby Mode in Less
Than 6 µ s
16-Bit RISC Architecture,
125-ns Instruction Cycle Time
12-Bit A/D Converter With Internal
Reference, Sample-and-Hold and
Autoscan Feature
16-Bit Timer_B With Three† or Seven‡
Capture/Compare-With-Shadow Registers
16-Bit Timer_A With Three
Capture/Compare Registers
On-Chip Comparator
Serial Communication Interface (USART),
Select Asynchronous UART or
Synchronous SPI by Software:
− Two USARTs (USART0, USART1)†
− One USART (USART0)‡
Brownout Detector
Supply Voltage Supervisor/Monitor With
Programmable Level Detection
Serial Onboard Programming,
No External Programming Voltage Needed
Programmable Code Protection by Security
Fuse
超低功耗:
- 主动模式:280μA,在1 MHz,2.2伏
- 待机模式:1.1μA
- 关闭模式(RAM保持):0.1μA
五省电模式
欠待机模式唤醒
超过6微秒
16位RISC架构,
125 ns指令周期时间
12位A/ D转换器具有内部
参考,采样和保持,并
AutoScan功能
16位Timer_B随着三† 或七‡
捕捉/比较随着阴影寄存器
具有三个16位定时器A
捕捉/比较寄存器
片上比较器
串行通信接口(USART),
选择异步UART或
同步SPI软件:
- 两个USART(USART0 USART1)的†
- 一个USART(USART0)‡
掉电检测
电源电压监控器/监视器
可编程电平检测
串行板载编程,
无需外部编程电压
安全可编程代码保护
融合-Low Supply-Voltage Range, 1.8 V to 3.6 V
Ultralow-Power Consumption:
− Active Mode: 280 µ A at 1 MHz, 2.2 V
− Standby Mode: 1.1 µ A
− Off Mode (RAM Retention): 0.1 µ A
Five Power Saving Modes
Wake-Up From Standby Mode in Less
Than 6 µ s
16-Bit RISC Architecture,
125-ns Instruction Cycle Time
12-Bit A/D Converter With Internal
Reference, Sample-and-Hold and
Autoscan Feature
16-Bit Timer_B With Three† or Seven‡
Capture/Compare-With-Shadow Registers
16-Bit Timer_A With Three
Capture/Compare Registers
On-Chip Comparator
Serial Communication Interface (USART),
Select Asynchronous UART or
Synchronous SPI by Software:
− Two USARTs (USART0, USART1)†
− One USART (USART0)‡
Brownout Detector
Supply Voltage Supervisor/Monitor With
Programmable Level Detection
Serial Onboard Programming,
No External Programming Voltage Needed
Programmable Code Protection by Security
Fuse
(系统自动生成,下载前可以参看下载内容)
下载文件列表
说明.txt