第一个发光管以间隔200ms闪烁

8个发光管由上至下间隔1s流动，其中每个管亮500ms,灭500ms,亮时蜂鸣器响，灭时关闭蜂鸣器，一直重复下去。

8个发光管来回流动，第个管亮100ms,流动时让蜂鸣器发出“滴滴”声。

用8个发光管演示出8位二进制数累加过程。

8个发光管间隔200ms由上至下，再由下至上，再重复一次，然后全部熄灭再以300ms间隔全部闪烁5次。重复此过程。

间隔300ms第一次一个管亮流动一次，第二次两个管亮流动，依次到8个管亮，然后重复整个过程。

间隔300ms先奇数亮再偶数亮，循环三次；一个灯上下循环三次；两个分别从两边往中间流动三次；再从中间往两边流动三次；8个全部闪烁3次；关闭发光管，程序停止。

-Interval between the first LED to blink 200ms

8 LED 1s intervals from top to bottom flow, where each tube light 500ms, OFF 500ms, when the buzzer sounds light, turn off the buzzer off has been repeated down.

8 LED back and forth, first a tube light 100ms, flow to the buzzer, "bit" sound.

LED with 8 out of 8-bit binary number shows cumulative process.

8 LED 200ms intervals from top to bottom, then from the bottom, to repeat, and then all went out again to 300ms intervals all flashes 5 times. Repeat this process.

Interval of 300ms for the first time a tube light flow again, the second of two tube light flow, followed by the 8 tube light, and then repeat the whole process.

Interval of 300ms the first odd and then even brighter light, circular three times　a light cycle up and down three times　two separate flow from both sides to the middle of three　again from the middle to both sides of the current three　8 Full flashes 3 times　off LED, the program stops.

朗读

显示对应的拉丁字符的拼音

字典- 查