搜索资源列表
pllwithunbalance
- PHASE LOCKED LOOP WITH UNBALANCE
My_NRflow
- 各个子文件介绍！！ 1.powerflow(主程序) 2.y(节点导纳矩阵) 3. run_NR (利用NR法计算潮流) 4. openfile (打开文件) 5. printY (显示Y矩阵) 6. newnode (节点重新编号) 7. Renode (还原节点) 8. form_jac (求取j矩阵) 9. dPQ (求取有功无功不平衡量) 10. PowerResult（计算节点电压相角
powerquality
- MATLAB,对电能质量的仿真，包括谐波，不平衡度，电压偏差-MATLAB, the simulation of power quality including harmonics, unbalance, voltage deviation, etc.
ForResUnd
- single degree of freedom vibration unbalance
RotUnbalance
- Rotor vibration unbalance analysis and absorber analysis
voltage_unbalance_rev2
- voltage unbalance paper
Ricatti-method
- 这是用于计算转子——轴承系统不平衡响应的程序，转子用集总参数法简化，轴承支撑为各项同性支撑-This is used to calculate the rotor- bearing system unbalance response procedure, the rotor with a simplified lumped parameter method, the bearing support for the homosexual
power_3phsignaldq
- A Discrete 3-Phase ProgrammableSource block is used to generate a 1 pu, 15 degrees positive sequence voltage. At t = 0.05 s the positive sequence voltage is increased to 1.5 pu. At t = 0.1 s an unbalance is introduced by
PLL
- The simulation file is the Phase lock loop with dq theory with unbalance input volatges
05552057
- The sensor nodes of a wireless grain depot surveillance system are deployed in crystal grids, which provide lot of valid position information. To avoid the energy consumption unbalance of the single hop routing
unbalance-of-3-p-current
- 基于labVIEW的三相电流不平衡度测试-LabVIEW:three-phase current imbalance degree test
92429
- 关于电网中，三相电压不平衡的计算、原因、危害等分析-On the grid, the calculation of the three-phase voltage unbalance, causes, and hazards analysis
THD
- 基于pscad的求取三相电压不平衡度的仿真模型，倾情奉献。-The strike on pscad unbalance three-phase voltage simulation model Decent.
MainUnbalanceThreePhaseProgram
- Main Unbalance Three Phase Program
very-important
- feeder reconfiguration for balance and unbalance distribution systems assuming varient load
Three-Phase-Unbalance-Measurement
- Labview设计的电压电流三相不平衡测量VI-Voltage and current unbalance measurement VI
s_048_12a
- 参考Matlab提供的模块建立简化的三相锁相环的仿真模型，只保留必要的步骤，如abc-dqz只计算Vq，去除频率反馈模块和自动参数调整模块等。 建立单相锁相环的计算模型 简化单相锁相环的系统结构，保留必要的PI控制器等模块 验证并讨论输入信号频率在45-65Hz变化时设计的锁相环的动静态性能 仿真并分析三相输入信号包含谐波、不平衡和直流偏移时锁相环的锁相结
RotorUnbalancedResponse
- 用ansys的beam单元计算转子不平衡质量响应的源代码-The beam unit calculates with ansys quality rotor unbalance response of the source code
Network-Reconfiguration-in-Balanced-and-Unbalance
- Network Reconfiguration in Balanced and Unbalanced Distribution Systems with High DG Penetration
VoltageUnbalace.rar
- Voltage Unbalance in networks Paper