搜索资源列表
7PWM-Test
- 这个程序主要运用于四路pwm波生成以及三路互补PWM波输出-pwm generation
pwm
- freescale DSP56f807环境下 PE模式输出六路互补PWM波，可用于驱动逆变器-freescale DSP56f807 environment PE mode complementary PWM wave output 6 Road can be used to drive inverter
EvPwm02
- 2812 PWM程序：初始化EVA，使得PWM1和PWM2输出互补的周期为1KHz的PWM波，占空比初始化为10 ，死区时间为4.27us-2812 PWM procedures: Initialize EVA makes PWM1 and PWM2 output complementary cycle 1KHz PWM wave, 10 duty cycle initialization, deadtime 4.27us
PWM-VHDL-Dual-complementary-outputs
- 基于单片机的双路互补PWM波输出设置，仅供参考，希望对需要的人有帮助。-Based on single-chip dual complementary PWM wave.
SVG_flash_20130618
- 运行环境为CCStudio v3.3。该程序为DSP TMS320F28335 初始程序，已经初始化EPWM，只要相应得改动输出比较寄存器就可以得到6组波形互补加死区控制的PWM波。-The program for the DSP TMS320F28335 initial program, has been initialized EPWM, may change as long as the corresponding output
02
- 初始化EVA，使得PWM1和PWM2输出互补的周期为1KHz的PWM波，占空比初始化 10 ，死区时间为4.27us。-Initialize the EVA, makes the PWM1 and PWM2 output complementary PWM wave for a period of 1 KHZ, 10 duty cycle is initialized, dead zone of 4.27 us.
epwm_comp
- 说明 环境：DSP28035 输入：13脚COMP1A 输出：55,56 EPWM1A EPWM1B 根据外部输入的电压和内部设定的比较值进行比较，经内部处理后输出不同占空比的PWM波，两路互补。-Based on DSP28035 About epwm and comp output
PWM1
- 输出两路pwm波,而且两路波形互补对称，需要的可以下载(Output two PWM waves, and the two waveform complementary symmetry)
TIM1_PWM 互补输出
- 配置TIM1的互补输出模式，输出两路互补的PWM波。(The complementary output mode configuration TIM1,PWM wave output two complementary.)
正点原子PWM
- stm32f4输出互补pwm波，用于电机，变频器的驱动。(Stm32f4 output complementary PWM wave.)
PWM互补死区输出
- 在STM32开发平台下，通过定时器的时钟配置，进行的PWM互补带死区的方波对电机进行控制。(Under the STM32 development platform, the PWM complementary square wave with dead zone is used to control the motor through the clock configuration of the timer.)