搜索资源列表
张课程设计
- 三点式振荡器是指LC回路的三个端点与晶体管的三个电极分别连接而成的电路，如图4-1（a）所示。图中三个电抗元件X1、X2、X3构成了决定振荡频率的并联谐振回路，同时也构成了正反馈所需的反馈网络。从相位条件看，要构成振荡器，必须满足： (1)极相连的两个电抗X1、X2性质相同。 (2)X1与X2、X3的电抗性质相反。-three-point refers to LC oscillator circuit with three transi
phoenix1.3.tar
- Phoenix is a speaker dependent (user trained) connected word recognition system. Phoenix is designed as a real-time recognition system in that recogniton takes place in parallel to utterance input and partial resul
railqk
- 最优平行轨道车皮排序问题 .问题描述： 在一个列车调度站中，k 条轨道平行连接到1 条侧轨处，形成1 条主轨道和k-1 条辅助 调度轨道。主轨道记为Hk，辅助轨道从下到上依次记为H1，H2，…，Hk-1 如下图所示。其 中主轨道左边为车皮入口（记为H0），主轨道右边为出口（仍记为Hk）。编号为a1, a2,L,an 的n 个车皮从入口依次进入主轨道，由调度室安排车皮进出轨次序，并对车皮按其出
JTAG
- This a c_based JATG.This code assumes that you have a JTAG parallel cable connected to your PC // Works with Xilinx parallel III or Altera ByteBlasterMV/
parallel
- I/O并行口直接驱动LED显示 利用AT89S51单片机的P0端口的P0.0－P0.7连接到一个共阴数码管的a－h的笔段上，数码管的公共端接地。在数码管上循环显示0－9数字，时间间隔0.2秒。 -I/O parallel port directly drive LED display using AT89S51 MCU port P0 is connected to P0.0-P0.7 digital control of a
parallel
- parallel connected pFC controller ac to dc dc to dc converter
2MW_wind_grid_inverter
- 针对兆瓦级风电并网逆变器主电路研制中存在的并联扩容、开关频率较低和LCL滤波器难以优化设计等问题，提出了采用交流侧串接电感再进行并联的均流方案，采用载波移相技术提高变流器的等效开关频率，提出了LCL滤波器的设计原则，并给出了上述设计的理论依据和实现方法。通过对2兆瓦风电变流器主电路的仿真验证了上述技术方案。-MW-class wind power for grid-inverter main circuit of the paralle
MCP2515_driver_s3c2440based
- 本驱动程序在s3c2440上实现了两路基于SPI的CAN总线控制器。两通道可以并行，并使用外部定义的两个信号量来通知接收任务收到CAN总线帧，并将其存入预先定义的队列中（帧定义在CAN总线控制器驱动程序的头文件中）。CAN总线控制器的中断引脚分别连接到ARM的EINT3和EINT8_23上-The driver s3c2440 achieved a two-way SPI-based CAN bus controller. Two ch
parallel
- This Project can be used in houses and offices in which more than one telephone is connected in parallel through a single telephone line Our project is used to connect a maximum of four telephones in parallel. When any o
parallelinverter
- basic parallel inverter
66
- Parallel-Connected Solar PV System to Address Partial and Rapidly Fluctuating Shadow Conditions
Power-Factor-Correction-With-Improved-Efficiency.
- A Parallel-Connected Single Phase Power Factor Correction Approach With Improved Efficiency
Nouveau-dossier
- strategy is carried out by inserting a switching matrix between the PV generator and the central inverter of the PO configuration system, which allows the electrical reconfiguration of the available PV modules in a
defer
- strategy is carried out by inserting a switching matrix between the PV generator and the central inverter of the PO configuration system, which allows the electrical reconfiguration of the available PV modules in a
IO parallel port drives LED display directly
- 利用AT89S51单片机的P0端口的P0.0－P0.7连接到一个共阴数码管的a－h的笔段上，数码管的公共端接地。在数码管上循环显示0－9数字，时间间隔0.2秒。(AT89S51 microcontroller using the P0 port P0.0 - P0.7 connected to a total Yin digital tube a - H pen section, digital tube common terminal
NRPTXK931
- 在一个列车调度站中,k 条轨道平行连接到1 条侧轨处,形成1 条主轨道和k-1,(In a train dispatching station, k railway parallel connected to one side rail, form 1 the main track and k - 1,)
83939163
- 在一个列车调度站中,k 条轨道平行连接到1 条侧轨处,形成1 条主轨道和k-1,(In a train dispatching station, k railway parallel connected to one side rail, form 1 the main track and k - 1,)
power_PVarray_3500W_me
- The SPS PV array model implements a PV array built of series- and parallel-connected PV modules. It allows modeling a variety of preset PV modules available from NREL System Advisor Model (Jan. 2014) as well as a user-de
power_4PVarray_400kW
- 400千瓦并网光伏电厂，包括四组光伏阵列，每组最大功率100Kw(400-kW Grid-Connected PV Farm The PV farm consists of four PV arrays delivering each a maximum of 100 kW at 1000 W/m2 sun irradiance. A single PV array block consist of 64 parallel strin
SINGLE PHASE TRANSFORMER-LESS GRID CONNECTED PV SYSTEM
- This code presents a single-phase, single-stage current source inverter (CSI) based photovoltaic system (PV) for grid connection. A double-tuned parallel resonant circuit is designed to attenuate the second- and fourt