搜索资源列表
Automatic Baud Rate Detection on the MSP430
- Automatic Baud Rate Detection on the MSP430
AN205SW
- cp210x非标波特率设置工具 CP210x Baud Rate Configuration Utility v1.0 Release Notes Copyright (C) 2004 Silicon Laboratories, Inc. This release contains the following components: * CP210xBaudRateAliasConfig.exe * CP210xManufacturi
LCD_DEMO-1
- lcddemo-1（2004版） -- 320X240 STN 灰度LCD 测试 此代码在SDT2.51下调试通过。运行时LED会闪烁一下，接着串口0会输出一些系统信息,在波特率为57600超级终端可看到,打印出来的由ASCII字符组成的 FS44B0X图样，此时LCD上显示ascii字符组成的ARM图样。通过串口终端与系统交互，可以测试320X240 STN LCD,包括图形显示函数，ascii字符显示函数。 -lcddem
51baudrate
- 51波特率计算辅助工具，可以选择晶振频率，然后输入你要的波特率，即可以帮你算出十六进制的数值。-51 baud rate calculation aids, can choose crystal frequency, and then you have to input the baud rate, which can help you calculate the hexadecimal values.
Auto_baudrate_detection
- Automatic Baud Rate Detection for the 80C51
FPGAprogram3
- 波特率发生器的设计，这里是实现上述功能的VHDL源程序，供大家学习和讨论。 -baud rate generator design, here is the realization of the above-mentioned functional VHDL source code for all learning and discussion.
SerialPort
- 实现串口的数据收发，设置串口的打开，波特率设置，收发进制转换-Serial data transceiver, set to open the serial port, baud rate settings, send and receive hexadecimal conversion
ckfs
- 向串口1（COM1）发送数据，波特率等参数("9600,n,8,1")-To the serial port 1 (COM1) to send data, baud rate and other parameters ( 9600, n, 8,1 )
serial
- linux 串口的配置,波特率,数据位,校验位,停止位,等等,以及串口的接收程序-linux serial port configuration, the baud rate, data bits, parity bit, stop bits, etc., as well as the serial port reception procedures
COMM
- 在DOS环境下，UART利用中断方式接收串口数据，并将接收到的数据从串口发送出去。串口地址为0xff80,波特率115200.-In the DOS environment, UART serial port to use interrupt receive data and receive data sent from serial port. Serial address 0xff80, baud rate 115200.
AutoBaudRate
- 本文是介绍C51自动检测传输波特率的方法及提供汇编程序-This article is an introduction C51 transmission automatic baud rate detection method and the provision of assembler
uart
- 基于FPGA的uart控制器，波特率可选，VHDL编程，Quartusii 6.0 平台，vhdl语言编程-FPGA-based UART controller, an optional baud rate, VHDL programming, Quartusii 6.0 platform, vhdl language programming
RS232_pro
- RS232 verilog coding 全参数化设计 可以自己设定波特率 时钟频率等 完全FPGA实现调通-RS232 verilog coding the entire parametric design can set the baud rate clock frequency of FPGA to achieve complete transfer pass
430UART
- MSP430单片机的串口通信程序，几种波特率。已调试成功，可用！-MSP430 MCU serial communication procedures, several baud rate. Have been debug successful, can be used!
UART_51
- 串口设置：包括初始化及应用；串口调试方面直接能用上-// This sample uses the UART to communicate with a PC. Therefore it sets up the internal // Baud Rate Generator (BRG). The LPC900 receives a command ( S ), sent by the PC and // sends out a
uart_zhiwen
- RS232的UART编程，包括波特率发生器模块，串口接受模块，串口发送模块-RS232 programming the UART, including the baud rate generator module, serial module to receive, send serial module
boundary_generator_using_T1
- 51单片机中的波特率发生器51 single-chip baud rate generator in-51 single-chip baud rate generator in
sci-autobaud
- 德州儀器新款DSP TMS320C2834X 晶片 SCI 自動 BAUD 偵測程式設計.-Texas Instruments new DSP TMS320C2834X chips BAUD automatically detect SCI programming.
autobaud
- set auto baud program
UART1
- C8051F130串口1测试程序，使用内部时钟，4倍频，100MHZ主时钟，波特率115200，发送什么数据，返回什么数据。发送数据采用查询方式发送，接收数据采用中断方式接收。-C8051F130 serial port a test program, using the internal clock, four multiplier, 100MHZ master clock, the baud rate 115200, send wh