搜索资源列表
MCU
- 超声波测距传感器-如何DIY一个属于你的超声波测距传感器。-Ultrasonic Distance Measurement Sensor- How to DIY a part of your ultrasonic range finder.
CSB
- DIY一个属于你的超声波测距传感器程序的构思和设计-DIY a part of your Ultrasonic Ranging Sensor concept and design procedures
document
- 硬件： 1. 车体 2. S3C2410A开发板 3. 红外测距传感器 4. 伺服器（舵机） 5. 直流电机 6. 电机驱动板 7. 电源 软件： 1. Linux2.6.14内核，包括：Nand Flash、USB、NET、PWM、ADC等驱动；Yaffs等文件系统。 2. VIVI 3. Busybox1.6 主要目标： 使车体能自主地在平地行驶，能躲避一定高度和大小的
Bat_Enlightenment
- 蝙蝠的启示 —— 用超声波测距传感器实现“瞄准”-Bat Enlightenment- the realization of ultrasonic distance measurement sensor, " targeting"
USED
- 夏普红外传感器GP2D12进行测距所需资料与原理图（手工绘制,传感器接口部分对照传感器的样子即知）已经程序-Sharp infrared sensors for distance measurement GP2D12 schematic diagram with the required information (hand-painted, sensor interface looks like part of the control
hwcj
- 基于STC89C51单片机的红外测距传感器的应用，涉及传感器应用、AD转换、单片机控制等。-STC89C51 MCU-based infrared sensors ranging applications, applications involving sensors, AD conversion, single-chip control.
Sensor data processing
- 处理传感器数据的程序，例如测距传感器。去掉一个最大值，去掉一个最小值，然后8个数据取平均值。结果去除了部分噪声，减少了误差。(program that deals with sensor data, such as a range finder. Remove a maximum, remove a minimum, and then take the average of the 8 data. As a result, partia
vl53l0x_arduino_master
- GY-530+VL53L0X激光测距传感器模块+ToF测距+飞行时间测距传感器(GY-530+VL53L0X laser ranging sensor module +ToF ranging + time-of-flight sensor)
新单片机超声波
- STC89C52单片机控制，用keil软件C语言编写的一段小程序，超声波测距传感器(STC89C52 single-chip microcomputer control, using keil software C language to write a small program, ultrasonic ranging sensor)
实验9-输入捕获实验0_1-超声波测距
- 根据正点原子输入捕获实验改编的超声波测距程序(ultrasonic ranging,ALIENTEK-STM32F103)
GP2D12 Infrared distance sensor
- GP2D12红外测距传感器应用，主控平台为51 ，开发环境为KEIL(GP2D12 infrared distance sensor applications, the main control platform for 51, the development environment for KEIL)
GY-53资料v1
- 基于vl53l0x的测距传感器的电路板，应用于0-1.2米测距。(Vl53l0x based range sensor circuit board, applied to 0-1.2 meters distance measurement.)
头盔姿态
- 定位测距，通过激光测距传感器测量出目标点的距离，再有陀螺仪计算出目标点的方位，就可以计算出目标相对于传感器的坐标(Location and ranging)
GY-VL53L0X资料
- 激光测距传感器调试代码和原理图，GY-530 VL53L0X 激光测距传感器 ToF测距 飞行时间测距传感器模块。(The debugging code and principle diagram of laser ranging sensor.GY-530 VL53L0X laser ranging sensor ToF ranging flight time ranging sensor module.)
激光测距基于51
- 使用51单片机，并用激光测距模块测距并在LCD上显示(Distance measurement and display on LCD)
超声波加红外测距传感器监控
- 在labview使用超声波传感器和红外传感器进行距离的监控，本程序监控了5个超声波传感器。(In the use of LabVIEW ultrasonic sensors and infrared sensors for distance monitoring, this program monitors 5 ultrasonic sensors.)
超声波测距资料
- 超声波测距，根据超声波指向性强,能量消耗慢,在介质中传播距离远的特点,利用超生波传感器对前方物体进行感应，经过单片机中的程序对超声波传感器发射和接收的超声波信号进行分析和计算处理，最后将处理结果在LCD1602上显示。(Ultrasonic ranging, according to the strong point of ultrasonic energy consumption is slow, the propagation ch
GY-530VL53L0X激光测距传感器模块
- 激光传感器的源码,gy530vl530l0x(gy530vl530l0x,for stm32f103)
VL53L0X激光测距传感器
- 使用VL53L0X型号激光测距模块测量距离 1.2m内(Use VL53L0X model laser ranging module to measure the distance within 1.2m)
1、STM32L031_硬件I2C_VL53L0驱动
- 激光测距传感器驱动，开发环境MDK，硬件IIC接口，MCU：stm32l031(Laser ranging sensor driver, development environment MDK, hardware IIC interface, MCU:stm32l031)