资源列表

« 1 2 ... .90 .91 .92 .93 .94 1795.96 .97 .98 .99 .00 ... 2139 »

[DSP编程SPWM---ad

说明:发出两路SPWM波形,并且获得AD转换,有八个转换口-Issued a two-way SPWM waveform, and get the AD converter
<柳叶> 在 2024-10-04 上传 | 大小:984064 | 下载:0

[DSP编程dsp-code-examples

说明:dsp的源代码,dsp320f28335必备资料-dsp320f28335 code examples
<张月生> 在 2024-10-04 上传 | 大小:15876096 | 下载:0

[DSP编程DSP28335--PWM

说明:用于产生F28335的PWM波,实现CAN通信,浮点数运算的说明,附带参考程序-to create PWM wave for F28335
<王思宇> 在 2024-10-04 上传 | 大小:1601536 | 下载:0

[DSP编程PWM

说明:基于89c52的PWM产生程序,简单易懂-The PWM generator based on 89c52, easy to understand
<秦园> 在 2024-10-04 上传 | 大小:1024 | 下载:0

[DSP编程ddr

说明:达芬奇系列开发板,ddr测试程序,用于检测Dsp和ddr之间的通路正常工作-Da Vinci series development board, DDR test program, used to detect between Dsp and DDR pathways to work normally
<卡卡罗特> 在 2024-10-04 上传 | 大小:57344 | 下载:0

[DSP编程RS485_R

说明:达芬奇系列开发板,rs485测试程序,用于检测DSP的rs485接口工作正常-Da Vinci series development board, DDR test program, used to detect between Dsp and rs485 interface to work normally
<卡卡罗特> 在 2024-10-04 上传 | 大小:66560 | 下载:0

[DSP编程omapl138_ccs5_2

说明:OMAPl138的基本外设源代码,FLASH的,IIC的,GPIO的,SPI的-OMAPL138 source program
<张阳> 在 2024-10-04 上传 | 大小:652288 | 下载:0

[DSP编程07_Sci02

说明:使用SCIA模块和PC机进行串口通信,等待PC机上的串口调试软件向DSP发送数据,DSP接收到上位机发送的数据之后,将这些数据发回PC机,显示在串口调试软件中。-Using SCIA module and PC serial port communication, Wait for the PC serial debugging software to send data to DSP, after DSP receiving the
<小鹏> 在 2024-10-04 上传 | 大小:476160 | 下载:0

[DSP编程LedFlash

说明:通过使用CPU定时器来控制LED灯D3的亮和灭,间隔时间由CpuTimer0来控制。-Using of the CPU timer to control the LED lamp D3 on and off .The time interval is controlled by the CpuTimer0.
<小鹏> 在 2024-10-04 上传 | 大小:292864 | 下载:0

[DSP编程EvPwm02

说明:PWM1和PWM2输出频率为1KHz的PWM波形。波形的占空比每隔1s变化5 ,范围在10 到90 之间。 -PWM1 and PWM2 output frequency of 1 KHZ PWM waveform.Waveform of the duty ratio changes every 1 s 5 , in the range between 10 and 90
<小鹏> 在 2024-10-04 上传 | 大小:283648 | 下载:0

[DSP编程AD01

说明:软件置位启动AD转换,实现ADC模块16路通道的采样。采样模式采用顺序采样。AD采样的触发方式采用软件置位的方式-Software setting start the AD conversion, the realization of channel sampling ADC module 16 road.In a sequential sampling mode.AD sampling way of trigger with the
<小鹏> 在 2024-10-04 上传 | 大小:449536 | 下载:0

[DSP编程X5043_SPI

说明:DSP2812与X5043的通信程序,读写都经过测试。希望对大家有帮助。-DSP2812 and X5043 communications program
<杨康佳> 在 2024-10-04 上传 | 大小:1428480 | 下载:0
« 1 2 ... .90 .91 .92 .93 .94 1795.96 .97 .98 .99 .00 ... 2139 »

源码中国 www.ymcn.org