资源列表
[单片机(51,AVR,MSP430等)] waveformsfasheng
说明:单片机构成的发生器可产生锯齿波、三角波、正弦波等多种波形,可通过按钮设定所需要的波形频率,并在LED上显示频率、幅值电压-SCM constitutes a generator can produce sawtooth, triangle, sine and other waveforms required by the button to set the waveform frequency, and the LED display<张玉坤> 在 2025-02-13 上传 | 大小:9kb | 下载:0
[单片机(51,AVR,MSP430等)] RA8803
说明:RA8803控制液晶显示模块,128*64分辨率液晶显示;-RA8803 control the LCD module, 128* 64 resolution LCD display<肖> 在 2025-02-13 上传 | 大小:480kb | 下载:0
[微处理器(ARM/PowerPC等)] CAN(Normal)
说明:STM32处理器上的CAN总线通信(正常模式)-STM32 processors CAN bus communication (normal mode)<wsm> 在 2025-02-13 上传 | 大小:424kb | 下载:0
[微处理器(ARM/PowerPC等)] CAN(LoopBack)
说明:STM32处理器上的CAN总线通信代码(回环模式)-STM32 CAN bus communication on the processor code (loop mode)<wsm> 在 2025-02-13 上传 | 大小:416kb | 下载:0
[单片机(51,AVR,MSP430等)] 51-DDS
说明:基于51单片机 DDS 的信号发生器设计 (有源代码)-51 MCU-based design of DDS signal generator (source code)<hezhigang> 在 2025-02-13 上传 | 大小:8.03mb | 下载:0
[单片机(51,AVR,MSP430等)] systick
说明:STM32 系统时钟实现多个时间定时,非常好用,方便-STM32 system clock timer multiple times<张风> 在 2025-02-13 上传 | 大小:1kb | 下载:0
[单片机(51,AVR,MSP430等)] gcysjs
说明:学校项目中一完整延时程序,通过对人数的检测,实现当人进入室内是自动打开饮水机加热系统 当室内无人时,延时大概十分钟后自动关闭-Delay the project a complete school program, through the number of testing it, when people enter the room is opened automatically when the room is no heati<张非> 在 2025-02-13 上传 | 大小:21kb | 下载:0
[VHDL编程] FPGA-based--DC-speed-controller
说明:针对某船舶模型定位系统中调速电机,以FPGA(现场可编程门阵列)为控制器,采用数字比例积分调节器实现电机的速度控制算法,设计出数字化调速控制器-Positioning system for a ship model in the motor speed, the FPGA (field programmable gate array) for the controllers, proportional integral regulato<史夏波> 在 2025-02-13 上传 | 大小:111kb | 下载:0
[单片机(51,AVR,MSP430等)] LCD(GCOG12864)
说明:基于msp430 设计的万年历(液晶屏用的lcd 12864)-Msp430 based design of the calendar (using LCD screen lcd 12864)<hezhigang> 在 2025-02-13 上传 | 大小:26kb | 下载:0
[单片机(51,AVR,MSP430等)] button-Keycan
说明:按键扫描,检测多个按键,支持长按,短按,按下,弹起检测。-Key scan, detects several buttons to support the long press, press, press, pop-up detection.<张风> 在 2025-02-13 上传 | 大小:2kb | 下载:0
[VHDL编程] loop-HELLO
说明:8位数码管循环显示HELLO.采用不同的延时时间,让数码管上HELLO,左右显示时的时间不同-8-bit digital control loop shown HELLO. With different delay time on the digital control HELLO, display different times around<刘达> 在 2025-02-13 上传 | 大小:374kb | 下载:0