资源列表

« 1 2 ... .11 .12 .13 .14 .15 64716.17 .18 .19 .20 .21 ... 66605 »

[其他小程序HVDC_VSC3

说明:三端柔性直流输电,pscad程序,可用于pscad初学者参考。(Three terminal flexible DC transmission, PSCAD program, can be used for reference for PSCAD beginners.)
<飞奔的Ant> 在 2025-02-12 上传 | 大小:63kb | 下载:0

[其他小程序MATLAB编程的潮流、短路、暂态稳定程序

说明:利用MATLAB编写的潮流计算、短路、暂态稳定的程序。(The program of power flow calculation, short circuit and transient stability is written by MATLAB.)
<飞奔的Ant> 在 2025-02-12 上传 | 大小:13kb | 下载:0

[其他小程序永磁同步风机仿真 pscad

说明:利用电磁暂态仿真软件pscad搭建的永磁同步风机仿真。(The simulation of permanent magnet synchronous fan is built by electromagnetic transient simulation software PSCAD.)
<飞奔的Ant> 在 2025-02-12 上传 | 大小:2mb | 下载:1

[其他小程序Quadrotor

说明:几篇有关小型四旋翼飞行器滑模控制的文章和复现(Several articles and reappearance of sliding mode control for small four rotor aircraft are presented.)
<背包> 在 2025-02-12 上传 | 大小:10.21mb | 下载:1

[其他小程序MMC

说明:利用pscad搭建的多电平直流输电模型,仅供参考。(The multilevel HVDC transmission model built by PSCAD is for reference only.)
<飞奔的Ant> 在 2025-02-12 上传 | 大小:489kb | 下载:1

[其他小程序dcBreakerModel

说明:利用电磁暂态仿真软件pscad建立的直流断路器模型(A DC circuit breaker model built by electromagnetic transient simulation software PSCAD.)
<飞奔的Ant> 在 2025-02-12 上传 | 大小:12kb | 下载:0

[其他小程序adres

说明:istence dashwoods. It satisfied to mr commanded consisted disposing engrossed. Tall snug do of till on easy. Form not calm new fail.
<bayrameser> 在 2025-02-12 上传 | 大小:96kb | 下载:0

[其他小程序单按钮控制的8个灯依次逐个点亮流水灯程序

说明:单按钮控制的8个灯依次逐个点亮流水灯程序(Single button controlled 8 lights, one by one, lighting the water lamp program one by one.)
<上善若淼> 在 2025-02-12 上传 | 大小:12kb | 下载:0

[其他小程序R_Princeton

说明:普林斯顿大学的R语言入门资料;简明扼要,言简意赅,方便学习,易于上手。(R Introduction from Princeton; easy to practice)
<supstone> 在 2025-02-12 上传 | 大小:704kb | 下载:0

[其他小程序2地控制电机启动与停止

说明:2地控制电机启动与停止,三菱PLC控制程序(2 control of motor starting and stopping)
<上善若淼> 在 2025-02-12 上传 | 大小:12kb | 下载:0

[其他小程序传送指令MOV的学习程序

说明:传送指令MOV的学习程序,三菱PLC控制程序(A learning program for sending instruction MOV)
<上善若淼> 在 2025-02-12 上传 | 大小:11kb | 下载:0

[其他小程序单按钮控制4台电机同时启动程序

说明:单按钮控制4台电机同时启动程序,三菱PLC控制程序(Single button control 4 motors at the same time start up program)
<上善若淼> 在 2025-02-12 上传 | 大小:12kb | 下载:0
« 1 2 ... .11 .12 .13 .14 .15 64716.17 .18 .19 .20 .21 ... 66605 »

源码中国 www.ymcn.org